
Firstly, you should install the APP on the phone; ( iSmartDV for the old A77; and DV
KING 4K if your camera firmware version is V6.1.0.1-B or higher. If you are not sure
about that, you can check your manual, too )
Secondly, press the “Wi-Fi” button on the camera to turn on the Wi-Fi function;
Thirdly, turn off 4G data of your phone and turn on Wi-Fi, and then
find the SSID and connect the Wi-Fi of APEMAN A77;
Finally, you can open the APP, connect the device and control it directly.
And please note that your phone may ask for permission for the first time you use it,
and you need to pass it, otherwise it will not work normally.
To turn off Wi-Fi, press up button again.
And here are some tips:
1).Please make sure you have turned off your Mobile phone data, VPN and so on, and
make sure it was under stable Wi-Fi internet.
2).Please connect the Wi-Fi first and then turn on the app.
3).Please make sure that the camera has enough power.
4).And you have to update the app to the newest version.
4. Why the Wi-Fi fails when I download the files ?
First, make sure your phone has enough space for you to download the files.
Then, please note that the Wi-Fi signal is the AC signal sent by the camera. So
sometimes it will become unstable, especially when you are downloading big file.
Therefore we suggest you don't put the camera too far away from your phone. Also
using the USB cable to transfer the big files is much more time-saving and power
saving.
5.Can you please give me some warm tips about the Wi-Fi function?
Here are some tips for you:
1).Press and hold the Up button again to turn off the Wi-Fi
2).The camera can only be connect to one device at a time
3).The Wi-Fi connection is a little bit power-consuming, so please avoid connecting
Wi-Fi when the battery power is low.
Remote Control and Other Accessories
1.Why the remote control doesn't work ?
First, check whether the light of the remote flash when you press it. Press the remote
for more times to activate the battery if haven't used it for a long time. Or you can
replace the battery--CR2025.
Then, turn on the camera and have a test. Normally it will work.
Do not press it continuously cause the camera needs sometime to react.
2.What is optimal range when using the remote control?
The maximum typically not exceeding 5 meters.