ITEM NO: AWM407
400 x 600 ●Max Weight 175 lbs.
For 40” – 75” TVs and
INSTRUCTIONS
CAUTION:
A CAUTION alerts you
to the possibility of damage or
destruction of equipment if you do not
follow the corresponding instructions.
Not following all instructions can
result in serious personal injury
and/or damage to equipment, or
voiding of factory warranty! It is the
installer’s responsibility to make sure
all components are properly
assembled and installed using the
instructions provided.
-5
NOTE: We recommend that this product is installed by a professional only. We
accept no liability for damages caused by incorrect assembly, installation or use. If
there is any doubt, please contact the specialist from the seller for help.
WARNING: Failure to provide adequate structural strength for
this component can result in serious personal injury or damage
to equipment! It is the installer’s responsibility to make sure the
structure to which this component is attached can support five
times the combined weight of all equipment. Reinforce the
structure as required before installing the component.
WARNING: Make sure that no electrical cables, water pipes or gas
pipes are located within the wall.
Tools required for installaon:
●Phillips head screw driver ●1/4” (6mm) Drill bit and Stud finder
(Drywall Installation)
●Electric or portable drill ●3/8” (10mm) Masonry bit (Concrete
Installation)
Also, make sure all the hardware has been included with our
mount. You should find the following:
A M8x63 Taping Screw X4 D M4x14 X4
B Concrete Anchor X4 E M6x14 X4
C 20*8.5*2 Washer X4 F M8x16 X4
G 16*6.5*2 Washer X4
Installation The Wall Mount
Drywall Installation Concrete Wall Installation
Using the stud finder and tape
measure to locate the stud behind
the dry wall.
Find a proper postion for mouting.
Do not drill at masonry joint.
Drawing the mounting hole by pen
Stud Finder Tape measrue Tape measrue
Tape measrue
Tape measrue
Spirit Level
Spirit Level
Drawing the mounting hole by pen
You can use spirit level or tape
measure to make sure horizontal and
vertical
You can use spirit level or tape
measure to make sure horizontal and
vertical
Drill hole with 5 mm wood drill
Drill hole with 8mm stone drill And
insert concrete anchor
Fixed the wall plate with screw(A)
and washer (C)
Fixed the wall plate with screw(A)
and washer (C)
H
