Apollo GX 55 User manual

Apollo GX55 Checklist (SAR Page)
Activate SAR Map Function
1. Press Map Key
2. Turn “large knob” CCW three times
3. Press Grid smart key four times, until grid 4
shows
4. Turn “little knob” to select zoom
*Note* will only work when SAR Function is loaded; advanced checklist loads
Grid Search (Parallel Line Search)
1. Press PAT Key
2. Parallel Line
3. Press Enter
4. Press SEL
5. Small Knob to adjust 1st Grid #
6. Large Knob to adjust 2nd & 3rd #
7. Press Enter
8. Press SEL
9. Large Knob to move curser to spacing and
direction
10.Small Knob to change reading
11.Press Enter
12.Large Knob CCW 1 click
13. Pat Key - Press

Apollo GX55 Checklist (SAR Page)
Creeping Line
1. Press SEL –INS flashes
2. Press Enter –Waypoint flashes
3. Press Enter
4. Turn “small knob” right/left to desired value
5. Turn “large knob” CW 1 click – Direction flashes
6. Turn “small knob” and “large knob” to desired dir
7. Press Enter
8. Turn “small knob” CW 1 click
9. Press SEL –5.0 flashes
10. Turn “small knob” right/left to desired value
11. Press Enter
Expanding Square (Based off of a User Waypoint)
1. Press SEL –INS flashes
2. Press Enter –waypoint type flashes
3. Press Direct TO
4. Press Enter –Spacing flashes
5. Turn “small knob” right/left to desire value
6. Turn “large knob” CW 1 click – direction flashes
7. Turn “small knob” & “large knob” to select the
desired direction
8. Press Enter
9. Press Enter –To activate search pattern
Mark Position (SAR Waypoint)
1. Press MRK smart key
2. Turn small & Large knobs to change name
(SAR000 will be automatic)
3. Press Enter
4. Press DIRECT TO or NRST to fly to SAR
Waypoint