Aprilaire 5660 User manual

D
A CB
1820, 1830, 1850, and 1870 Series
Dehumidifier Hanging Kit
Model 5660 and 5691 | Specification Sheet
and Installation Instructions
MODEL 5660 MODEL 5691
Compatible with
Dehumidifier Models
1820, 1830 & 1850
Compatible with
Dehumidifier Model 1870
AWidth 18" 27"
BInside Rail Width 6⁄" 10½"
COutside Rail Width 9⁄" 13½"
DLength 29⅞" 35"
SPECIFICATIONS
Model 5660
Hanging Kit
5691
Hanging Kit
Dimensions: (Hanging Kit Only)
Width
Height
Length
18"
6⁄"
29⅞"
27"
6⁄"
35"
Weight 13 lbs. 18 lbs.
Weight: (Working Load) 400 lbs. 400 lbs.
Shipping Weight: (w/Carton ) 14.6 lbs. 19.7 lbs.
MODEL 5660/5691
DEHUMIDIFIER HANGING KIT
+ 14 gauge zinc-plated steel
+ 1/4" thick black neoprene pads for vibration insulation
+ 10' cables with Gripple®clamps and 3 1/2" bolts
+ Total safe working load 400 lbs.
+ Parts bag includes (4) 3/8" flat washers, (4) 3/8"
hex nuts, and Gripple key

AprilairePartners.com
Form No. 914 • 277192 10.17
©2017 Aprilaire – Division of Research Products Corporation
APRILAIRE RESERVES THE RIGHT TO CHANGE SPECIFICATIONS WITHOUT NOTICE.
P.O. Box 1467
Madison, WI 53701-1467
800.334.6011 F: 608.257.4357
Installing an Aprilaire Dehumidifier
with Model 5660 and 5691 Hanging Kits
Unfold the hanging bracket so the support
bars are perpendicular to the hanging bars.
2
Use two washers and two nuts on each
cable bolt when mounting the hanging
bracket to a structure. Make sure the
structure can support the weight of the
hanging bracket and dehumidifier.
3
Extend the dehumidifier feet
approximately 3/4" to 1".
4
Adjust the height of the hanging bracket
by either pulling on the cable or inserting
the Gripple key to release tension.
CAUTION:
BRACKET AND DEHUMIDIFIER
MUST BE SUPPORTED WHEN KEY
IS USED TO RELEASE THE CABLE.
Set a level on top of the dehumidifier to
make sure it is level in both directions.
With the feet extended, center the
dehumidifier on the hanging bracket,
with the feet outside of the support bars.
5
6
7
1Open box and remove the contents.
Contents include:
+ Hanging bracket with cables and bolts
+ 8 nuts, 8 washers
+ Gripple key
+ Installation instructions