2. Operating instructions
2.1. Assembly
2.1.1 Inspection before packing
1. Read and understand this manual and be qualified by proper instruction for sport
parachuting activities
2. Check both 3 –Ring releases to see that they are correctly assembled, and the release
handle is securely with Velcro to the main lift web
3. Check the main container closure for the correct pin position and the correct routing of the
bridle.
4. Check the reserve container for the correct pin closure and routing of the ripcord. Be sure
the reserve ripcord handle is well seated in its Velcro pocket.
5. The main pilot chute must be protected by its pouch, but the handle must be easily visible
and accessible
6. Ensure that the reserve and main canopy size is compatible with the harness-container and
deployment system with which it is to be used
7. Prior to assembly and/or packing a thorough inspection of the AVALON harness/container
must be completed.
- Reserve container
- Main container
- Harness
- All cable housings
- All stitching
- All grommets
- Reserve handle integrity and correct size fitted
- Cut away housing integrity and correct size fitted
- Reserve risers and deployment brake system
Check for any worn, damaged, corroded or incorrectly rigged components, which must be
repaired or replaced before the harness container is packed for use
For Reserve canopy installation, read and follow the instructions included in the Reserve
canopy instruction manual.
2.1.2. Reserve canopy assembly
If soft links are used follow the instructions below:
1 2 3 4 5 6
