- 2 -
1. GENERAL
A) Carefully read the following im ortant information regarding installation safety and
maintenance. Kee this information booklet accessible for further consultations.
B) The a liance has been designed as a exhausting version (external exhaust) or as a filter
version (inter air recycle) cooker hood.
2. SAFETY PRECAUTION
A) Take care when the cooker hood is o erating simultaneously with an o en fire lace or burner
that de end on the air from the environment and are su lied by other than electrical energy,
as the cooker hood removes the air from the environment which a burner or fire lace need for
combustion.
B) The negative ressure in the environment must not exceed 4 Pa (4*10-5 bar).
C) Provide adequate ventilation in the environment for a safe o eration for the cooker hood.
D) Follow the local laws a licable for external air evacuation
E) A liance shall only be used with rated voltage and frequency.
F) There is a fire risk if cleaning is not carried out in accordance with the instruction.
3. WARNING!!
In certain circumstances electrical a liances may be a danger hazard.
A) Do not check the status of the filters while the cooker hood is o erating.
B) Do not touch the light bulbs after a liance use.
C) Do not disconnect the a liance with wet hands and without to force the su ly cord..
D) Flame cooking is rohibited underneath cooker hood.
E) Avoid free flame, as it is damaging for the filters and a fire hazard.
F) Constantly check food frying to avoid that the overheated oil may become a fire
hazard .
G) Disconnect the electrical lug rior to any maintenance.
H) Children don’t recognize the risks of electrical a liance. Therefore use or kee the
a liance only under su ervision of adults and out of the reach from children.
4. INSTALLATION INSTRUCTIONS
Way one:
4.1 The cooker hoods should be laced at a distance of 65-75cm from the cooking surface for best
effect.
4.2 To install onto the wall drill 2 holes of Ø8mm on a suitable lace according with the centre
distance of hole in the back of the cooker hood.
4.3 Insert the nut into the holes.
4.4 Insert the screws into the nuts and tight.
4.5 Put u the cooker hood onto the tighten screws.