User’s manual – AREBOS Kettle with color change
4
•To avoid possible steam damage, not face the spout when operating the kettle.
•If operated on wood furniture, use a protective pad to prevent damage to delicate finishes.
•To avoid scalding, always ensure the lid is correctly positioned before operation.
•Scalding may occur if the lid is removed while heating.
•Remove and replace the lid carefully when hot.
•Extreme caution must be used when moving the kettle containing hot water. Never lift the
kettle by its lid. Always use the body handle.
•Do not switch your kettle on, if it is empty.
•To protect from electrical hazard, do not immerse this kettle, power base or cord set in any
liquid.
•Use the kettle only with the supplied base unit. Do not use the base unit for other purposes.
•While the water boiling or in the short time after the water boils, please be sure that do not
attempt to open the cover for avoid the steam scalding your hand.
•Please avoid the liquid sprinkling in the LCD board and the pressed key place in the operating
process. Because the water possibly can plunge in the product, causes the function to be
unusual.
•Please do not have to add surpasses the maximum water volume, because this has the
possibility to damage the product.
•Please regular clean descale or pot bottom residuum, because this possibly can affect the
normal use of the product.
•If the supply cord is damaged, it must be replaced by the manufacturer.
•This appliance should not be used by persons, including children, with reduced physical,
sensory, or mental capabilities or lack of experience and knowledge, unless they were
supervised by the person who is responsible for their safety.
2)Commissioning
2.1 Before first use
1) Fill the kettle with clean water to maximum capacity and boil. Discard the water and repeat
the process.
2) The kettle should always be unplugged when filling or adding water.
3) Filling the kettle with water to desired level. Do not overfill or there will be a risk of spillage
or spitting. The water level indicator will assist you to measure the correct amount. You can
fill the kettle via the spout or after opening the lid. Do not forget to close the lid after filling,
otherwise the kettle will not automatically switch off after use.
4) Do not fill with more water than the maximum indication.
5) Do not fill with less water than the minimum indication to prevent the kettle from running
dry while operating.
6) An automatic safety cut-out has been fitted for protection against overheating. It will operate
if the kettle is switched on when containing insufficient water. Always ensure the water
inside the kettle covers the minimum mark on the water level indicator gauge. If the
automatic safety cut-out has operated, switch the kettle off, disconnect from the power
outlet and allow the kettle to cool down for 5 to 10 minutes. Then refill and switch on, the
kettle will work as normal.
7) After boiling, the kettle switches off automatically. Disconnect the kettle from the mains
electricity supply. Do not open the lid when pouring. If the kettle is overfilled, boiling water
may be ejected.
