Argo Flamenco User manual

8
V 09/16
OPERATING INSTRUCTIONS
Read the instructions carefully before installing and operating the appliance or performing
maintenance operations. Observe all the safety instructions; failure to observe the instructions may
cause accidents and/or damages. Store these instructions for future reference.
ELECTRIC FIREPLACE
EN

9
V 09/16
GENERAL SAFETY INFORMATION
Use this electric fireplace only as outlined in this manual. Any other
use not recommended by the manufacturer may cause fire, electric
shock or injury to people.
Ensure that the mains power complies with the voltage specified on
the electric fireplace data plate (220-240V~/50Hz).
This appliance can be used by children aged from 8 years and
above and people with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children
without supervision.
This product is not a toy. Children of less than 3 years should be
kept away unless continuously supervised.
Children aged from 3 and less than 8 years shall only switch on/off
the appliance provided that it has been placed or installed in its
intended normal operating position and they have been given
instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children aged from 3 years and
les than 8 years shall not plug in, regulate and clean the appliance
or perform user maintenance.
CAUTION - Some parts of this product can become very hot
and cause burns. Particular attention has to be given where
children and vulnerable people are present.
WARNING: In order to avoid hazard due to inadvertent resetting of
the thermal cut-out, this appliance must not be supplied through and
external switching device, such as a timer, or connected to a circuit
that is regularly switched on and off by the utility.
WARNING: do not use the electric fireplace with a controller or
any other external device that activates the appliance
automatically, as there may be a risk of fire if the electric
fireplace is covered or incorrectly positioned.

10
V 09/16
Do not restrict the air inlet and outlet grilles.
The appliance heats up slightly when in use. In order to avoid burns,
do not let bare skin touch hot surfaces.
Ensure that all objects are at least 1 meter from the front and sides
of the appliance.
Disconnect the mains power when the appliance is not used or for
cleaning operations.
Avoid using the electric fireplace in dusty environments or in the
presence of inflammable vapors (e.g. in workshops or garages) or
paint vapors.
Do not place anything on the appliance, use the appliance to dry
clothing.
Use the appliance in a well-ventilated area.
Avoid placing fingers or foreign objects in the air inlet/outlet grilles,
as this may lead to electric shock or fire and may damage the
appliance.
To avoid the risk of fire, do not block the grilles or tamper with them
in any way while the electric fireplace operates.
Do not use the appliance if the cord or plug are damaged. If the
power supply cord is damaged, it must be replaced by the service
centre so as to avoid any safety risks.
Do not operate the appliance if it has fallen from a height or has
suffered damage in any way. Contact qualified technical personnel
to examine the appliance or perform any electrical or mechanical
repairs.
The most common cause of overheating is the build-up of dust in
the appliance. Remove dust deposits by unplugging the appliance
and cleaning the air outlets and grilles with the aid of a vacuum
cleaner.
Do not use abrasive detergents for cleaning this appliance. Clean
the appliance with the aid of a damp (not wet) cloth rinsed in hot
soapy water. Always remove the plug from the mains socket before
cleaning.

11
V 09/16
To disconnect the electric fireplace, push the switch to OFF and
remove the plug from the socket. Pull on the plug only. Avoid pulling
on the cord when disconnecting the electric fireplace.
Do not place any objects on the cord and do not bend it.
It is not advisable to use extension cords, as these may overheat
and cause the risk of fire. Do not use a single extension cord to
operate multiple appliances.
Do not immerse the cord, plug or any other element of the appliance
in water or other liquids.
Do not touch the plug with wet hands.
Do not place the fan heater above or near another heat source.
WARNING: AVOID COVERING THE ELECTRIC FIREPLACE TO
PREVENT IT FROM OVERHEATING.
The symbol below signals the above warning:
The electric fireplace may cause the risk of fire if, while in operation,
is covered by or comes into contact with inflammable material
including curtains, drapery, blankets, etc. KEEP THE ELECTRIC
FIREPLACE AWAY FROM THESE MATERIALS.
Do not connect the appliance to the mains power before it has been
properly assembled and positioned.
Do not run the cord under carpets. Do not cover the cord with
blankets, carpets or similar materials. Place the cord far away from
busy areas or where it cannot be accidentally pulled-out.
Do not operate the electric fireplace in close proximity to bathtubs,
showers, washbasins or pools.
Do not position the electric fireplace below a socket outlet.
Do not operate the appliance outdoors.
Upon initial start-up, the electric fireplace may emit a slight,
harmless smell. This smell is a normal effect of the initial heating up
of the internal heating elements, and should not recur later on.

12
V 09/16
WARNING: DO NOT DEPEND ON THE ON/OFF BUTTON
SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER.
WHEN SERVICING OR MOVING THE ELECTRIC FIREPLACE,
ALWAYS UNPLUG THE POWER CORD.
A electric fireplace has hot and arcing or sparkling parts inside. It
must not be used in potentially dangerous locations such as
flammable, explosive, chemical-laden or wet atmosphere.
Do not place the electric fireplace on soft surfaces, like a bed, where
openings may become blocked. Always place the electric fireplace
on a stable, flat, level surface when operating, to avoid the chance
of the electric fireplace overturning. Locate the power cord so the
electric fireplace or other objects are not resting on it.
Always unplug the electric fireplace when not in use.
In order to avoid accidents turn unit off if unattended.
In the event of any problems (abnormal noise or a strange smell)
switch off the appliance immediately, do not attempt to repair it and
take it to your local after sales service.
DESCRIPTION OF PARTS
1. Air outlet grille
2. Overheating safety device
3. ON/OFF switch
4. ECO mode
5. COMFORT mode (selecting both 4 e 5)
DESCRIPTION OF PARTS
Put the electric fireplace vertically on a flat and stable surface. Use the rear handle when you move the appliance.
Connect the power cord to a suitable electric socket (220-240V~/50Hz).
34 5
1
2

13
V 09/16
Turn on the On/off switch.
Select the desired mode:
(1) ECO mode: switch under ON/OFF button (1000W)
(2) COMFORT mode: switches (4) and (5) together (2000W)
CONTROL PANEL AND AVAILABLE FUNCTIONS
The appliance is fitted with an anti tip-up device that prevents it from operating when it detects that the product is inclined.
Do not position the appliance on its side or upside down.
OVERHEATING SAFETY DEVICE
In case of overheating the safety cut out protecting the heating element will automatically switch off the appliance.
In this case the appliance stops working. If this happens:
remove the causes of abnormal operation or overheating (i.e. obstacles in front of air inlet or air outlet grille);
leave the electric fireplace cool down for 15/20 minutes;
switch on again the fireplace.
MAINTENANCE AND STORAGE
ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE.
IMPORTANT: DO NOT SUBMERGE THE CERAMIC ELECTRIC FIREPLACE IN WATER
Cleaning the outside surface of the appliance
Turn the switch off and unplug before carrying out any maintenance work or moving the appliance.
Use a soft cloth to remove any dust from the electric fireplace.
If the electric fireplace is excessively dirty, use a soft cloth moistened with water and a mild detergent at a temperature lower
than 50°C. Let the fan heater dry completely before use.
Do not use corrosive detergents or solvents such as petrol. Do not wash the appliance with water. Do not use oils, chemical
substances or other items to clean that may damage the surface.
Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.
STORAGE
If the appliance is not used for prolonged periods, it must be stored together with this manual in its original packaging, in a
cool and dry place.
INFORMATION FOR THE CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EUROPEAN DIRECTIVE
2012/19/EU
This appliance may not be scrapped with domestic waste at the end of its life cycle. We call your attention to the crucial role
played by the consumer in the re-use, recycling and other forms of recovery of such waste. The appliance must be scrapped
by a sorted waste disposal centre or by returning it to the retailer (no charge is levied for this service), when you purchase a
new equivalent appliance. Sorted disposal of electric and electronic equipment prevents the negative effects on the
environment and human health resulting from improper scrapping, and also allows the materials from which it is made to be
recovered and recycled, with significant savings in terms of energy and resources. The sorted disposal requirement is
indicated by the crossed wastebin label affixed to the appliance.
www.argoclima.com
ECO mode (I): (1)
(
1000W
)
ON/OFF
COMFORT mode (I + II):
(2) (2000 W)