Arlotto AR6220 Series User manual

AR6220/AR6230 Quick Installation Guide
PACKAGING CONTAINS
2Bracket 1Camera 3Anchors/screws 4Power adaptor 5CD 6Drill template
SETUP
1Locate the place where the camera would be installed and
place the drill template to make the fixation drills. Also mark
the place where to drill the hole to pass the cables through
the wall.
3Connect the bracket and tighten the screws until the retainers are
firmly seated.
2Place the camera in the floor or a safe location and pass the
cables through the camera bracket.
4Connect the cables and pass the cables through the wall hole.
5Tight correctly the bolts.
6Connect the Ethernet cable and DC or POE power input to the
camera and proceed to find your network camera in your web
browser, if you would like to add audio, alarm trigger connection
or others please use included connections.
7Once camera is connected to the network please open Internet
Explorer and go to “tools”, then select “internet options”, the click
on “security” tag and click again on “custom level”. A new window
would be open. Scroll down the list and tick on prompt at
“download signed ActiveX controls” and “Download unsigned
ActiveX controls”.
6Use the drill template to make the drill location marks in the wall
and fix the bracket to the wall.

AR6220/AR6230 Quick Installation Guide
SETUP
10 Once ActiveX is loaded the network camera login window would
be shown, please type “admin” at user and “123456” at password.
Default User Name : admin
Default Password : 123456
9Restart the IE web browser and type at the web address window
192.168.1.168 this would redirect the browser to the network
camera and require you to install the ActiveX. Please follow the
indications.
11 Submit the access data and you would log in the network camera
control interface, now you can control and change all camera
settings.
12 If you would like to restore network camera factory settings
please open the camera and power it on, press the reset button
for 10 seconds. The camera would revert to original status.
HARDWARE LIMITED WARRANTY
What is covered: This warranty covers any hardware defect in materials of workmanship, with the exceptions stated bellow.
How long coverage lasts: This warranty lasts for 2 years from the date of the purchase by the original end-user customer.
What is not covered: This warranty does not cover cosmetic damage or any other damage caused by abuse, misuse, and neglect use in violation of the
instructions, repair by any 3rd. party or an act of God. Aslo if serial number has been altered,defaced or removed, further to this consequential and incidental
damages are not revocable by this warranty. Lenses, hard drives and solid state memory warranty is limited to 1 year.
What Manufacturer will do: Manufacturer will in our sole discretion repair or replace any product that proves in material of workmanship, any repair or
replaced part would be covered by 3 months warranty extension. During the warranty period the manufacturer would cover 1 way of the transportation and
customer the other way. After warranty is expried the transportation cost shall be paid by the customer.
How to get service: Contact your authorized distributor in your region or contact manfacturer directly if there is not distributor in your country. Please check
www.arlotto.com website for more information about RMA and to get support.
Your rights: European Union and some States do not allow exclusion or limitation of consequential or incidental damages, so the above exclusion or
limitation may not be apply to you. This warranty gives you specific legal rights; you may also have other rights which vary from State to State.
8Once this is done accept the chances and the window would
close. Now select “trusted sites” and click on “sites” and at the
new window low area type the network camera default IP number
“192.168.1.168”, and tick at “Require server verification for all
sites in this zone” then add it and save all the changes.