arte confort Rodas User manual

ON/OFF
Lámpara
Programación
Velocidad
Modo
invierno/verano

EN
6
CAUTION
• The product must only be installed by an
authorized electrician and in compliance with
local, regional and state electricity regulations.
•Check if the electrical specications of this
device are compatible with your installation.
•Turnothepowerbeforeinstallingorrepairing
the fan.
• The fan must be properly grounded to avoid the
risk of electric shock.
•Use and unauthorized technical modications
could suppose a risk of injury.
• The fan must be connected to a 240V 50Hz
power supply.
• Do not connect the fan motor to a current
dimmer. It could give unsatisfactory performance
(engine humming) and cause engine damage.
• Be careful while working near the spinning
blades.
• Never connect the fan to a power point but to
the ceiling itself.
• The fan must be installed so that the blades are
at least 2,3 meters above the ground.
• The fan must be hung from a structure capable
of supporting a weight of at least 50 kg. The
xturemustbeabletosupporttheweightofthe
fan in motion and should not wobble or loosen.
• Make sure that the blades do not come in
contact with any object at the installation site.
Always leave a minimum clearance of 50cm
from the tip of the blades to the wall or ceiling.
WARNING
Read this instruction manual carefully before
beginning installation and save it for future
reference. In case of transfer of the device, you
must also give this instruction manual to the
corresponding person.
While using electrical appliances, basic safety
precautions should always be followed to reduce
theriskofre,electricshockandpersonalinjury.
Keep in mind that the larger this space, the
betterthefan’sairowwillbe.
• This device is designed for indoor use only. Do
not use in an open space or where it may be
exposedtowaterormoisture.
• Never install the appliance in a room with a
high degree of humidity.
• The fan must not be started in a room with a
gas appliance running at the same time.
• This device can be used by children aged 8
years and above and of people with reduced
physical, sensory or mental abilities or lack of
experienceandknowledgeiftheyaresupervised
or instructed about the use of the device safely
and understand the risks involved. As well as
cleaning and maintenance of the device.
• Children should not play with the device.
• Before reversing the direction of rotation of the
blades stop the fan completely. This will prevent
any damage to the fan motor or controller (if
installed).
• Do not insert any object into the fan blades
while they are rotating. This can damage them
and alter the balance of the fan and the device
can fall down.
• After the fan is fully installed make sure all
fasteners are securely fastened to prevent any
wobbling or falling of the machine.
The instructions and safety regulations in this
manual cannot prevent all conditions and
situations that may occur. For obvious reasons,
this manual cannot include factors such as caution
and care. These factors must be assumed by who
installs, maintains, uses and enjoys the product.
THANKS FOR TRUSTING IN
ARTECONFORT
Congratulations, you have just purchased an
Arteconfort ceiling fan: cutting edge technology
combinedwiththehighestenergyeciency.

EN
7
BEFORE INSTALLATION
Open the box avoiding the use of blades or
“cutters” to avoid scratching the fan components.
Unpack the parts handling them carefully so that
they do not bend or scratch, and place the motor
on a cloth or a soft surface to prevent damage
(you can also use the anti-shock foam on the
box for this purpose). Never support the motor
sideways.
Itisadvisabletomountthefanontheoorora
surface large enough so that no component falls.
Identify all parts before beginning assembly.
TOOLS NEEDED
*Not included. It is recommended that the
screwdriver be magnetized.
PROBLEM SOLVING
Before carrying out the checks detailed below, the
fan must be without power supply.
1. The fan does not start
• Replace the remote control batteries if they are
exhaustedornotsuitable.
• Check that there are no nearby devices that
may be causing interference with the remote or
reducing signal reception.
• Resynchronize the remote control.
• Check that the electrical connections are correct
(must be carried out by a licensed electrician).
• Check fuses and switches, that the installation
has voltage and it reaches the fan.
2. The fan makes excessive noise while
rotating
• Allow a slight separation between the canopy
and the ceiling, preventing them from touching
directly.
•Check that the xing screws of the blades,
thexingscrewstotheroof,thestem andthe
fastening elements are correctly tightened.
• If you replaced the original remote control or
receiver, reinstall the supplied ones along with
the fan.
3. The fan wobbles
•Check that the xing screws of the blades,
thexingscrewstotheroof,thestemandthe
fastening elements are correctly tightened.
• Check that the blades are not deformed and
follow the blade balancing instructions detailed
in this manual.
4.Theairowisinsucient
• Check that the blades rotate in the correct
direction (Summer / Winter).
• Avoid nearby objects that may impede air
circulation.
• Verify that the diameter of the blades of your
fanissucientfortheareaoftheroominwhich
it is installed.
5.Thelightdoesnotturnon
• Check the bulb is not blown, otherwise replaces
it with a new one.
• If your fan has LED light included, check the
connectionsareproperlyxedaccordingtothe
instruction manual.

ON/OFF
Fan
ON/OFF
Lamp
Timer
Speed
Winter/summer
mode

ON/OFF
Ventilador
ON/OFF
Lâmpada
Relogio
automatico
Velocidade
Modalidade do
inverno/verão