Aruba Networks AP-103H-MNT1 User manual

AP-103H-MNT1 Mounting Kit
Installation Guide
0511626-01 | April 2014 1
Package Content
Single Gang Wall-box Mounting bracket
2x #6-23 Machine Screws
Security Key
Installation Guide (this document)
Installation
1. Begin by removing the existing data wall plate (if applicable).
Figure 1 Removing Wall Plate (Standard US Single Gang Outlet Box Shown)
2. Remove any existing RJ45 connectors (typically snap-in) or cut/remove the UTP cable.
3. Use a short Ethernet cable (sold separately) to connect the ENET0 port to an RJ45 connector or crimp
an RJ45 plug (not supplied) on the cable and insert in the ENET0 port. Do the same for the Pass Through
port, if used.
4. Align the mounting holes of the AP-103H mounting bracket with mounting holes in you gang box as
shown in Figure 2 and Figure 3. For worldwide single gang outlet box, the mounting bracket provides
two sets of mounting holes for fixing to the box to meet different installation position requirement. See
Figure 3 for details.
The applicable standards for the wall boxes are:
IEC 60670-1, GB17466, BS4662 and DIN49073 for Worldwide
ANSI/NEMA OS 1 and OS 2 for US
5. Insert the two included mount screws and tighten them to secure the mounting bracket.
The included machine screws may not fit all wall boxes.

2 AP-103H-MNT1 Mounting Kit | Installation Guide
Figure 2 Bracket to Gang Box (US Single Gang Outlet Box Shown)
Figure 3 Bracket to Gang Box (Worldwide Single Gang Outlet Box Shown)
6. Connect any required cables to the rear of the AP-103H.
7. Align the mounting posts on the back of your AP-103H with the corresponding mounting holes on the
mounting bracket as shown in Figure 4.
8. Push the AP against the holes and downward until the posts engage the slots at the top of the mounting
holes. See Figure 4 and Figure 5 for more details.
Figure 4 AP-103H to Bracket
AP-103H_04
AP-103H_07
Another
two
mounting
holes
AP-103H_05

AP-103H-MNT1 Mounting Kit | Installation Guide 3
Figure 5 Completed Installation
9. To remove the AP-103H from the mounting bracket, begin by inserting the security key into the hole as
shown in 11..
10. Use the security key to depress the tab on the AP and push the AP up, releasing the AP from the
mounting holes on the bracket.
Figure 6 Removing the AP-103H
11. If not using PoE, connect the AC-DC power adapter (sold separately) to the DC power socket located on
the bottom of the AP-103H.
AP-103H_06

4 AP-103H-MNT1 Mounting Kit | Installation Guide
This page is intentionally left blank.