Atec T3S User manual

. PROFESSIONAL LOW BATTING TEE
GENERAL CARE
+ To clean, wipe stem with mild detergent soap mixed with water, use
clean towel to dry.
+ Do not add additional lubricant to tee stem pieces.
+ Do not over tighten T Screw, a snug fit is sufficient
+ When not in use, store in cool, dry environment.
+ If needed, a 10 pound (lbs) weight can be placed on the tee base to
increase stabilization during use.
Your T3s comes with a 1-year Limited Warranty.
Under normal use and care ATEC guarantees, to the original owner, the
T3s to be free from defects in materials and workmanship.
During this period ATEC will repair or replace with new or refurbished
components, at ATEC’s sole discretion, any component found to be
defective without cost to the owner, provided the defective product is
returned to the factory at the owners expense. Proof of purchase may be
required by ATEC to approve certain warranty claims.
WARRANTY
ATEC Customer Service
(p) 1.800.755.5100
(e) [email protected]
QUESTIONS?
A - Cone
B - Shrink Tube
C - Stem Top Tier - Composite
D - Stem Bottom Tier - Aluminum
E - Base
F - Stem Receptacle
G - Expansion Plug
H - T Screw
FRAME
PARTS
T3s
GH
BASE VIEW UNDER BASE VIEW
ASSEMBLED VIEW
MODEL: WTATT3S00
A
C
B
D
F
E

. PROFESSIONAL LOW BATTING TEE
T3s
Place the Stem (D)
completely over the Expansion Plug (G).
Turn the T-Screw counter-
clockwise four full rotations to loosen stem. DO NOT
completely remove/unscrew the T-Screw, as this is not
necessary. Stand on the Base and
Lift up on the Stem to
separate the Stem from
the Base.
While holding the stem over the expansion plug, turn the T-Screw (H)
clockwise to secure stem to base (Four clockwise rotations).
QUICK START
SET UP TAKE DOWN
STEP 1: STEP 2:
STEP 3: STEP 4:
1
4
2 3
x4 x4