AUTOTECH 10.199.500K User manual

Installation Instructions
Part Number: 10.199.500K
Description: Mk5 GTI, Jetta, and Rabbit Lower Engine Mount Insert
Tools Required:
Floor Jack, Jack Stands, 21mm socket and torque wrench
Procedure:
1. Raise front of car high enough to fit jack stands under vehicle.
2. Position jack stands under car using factory lift points.
3. Loosen and remove the bolt that holds the pendulum mount (aka “dog bone”) mount into the round bushings in the sub-
frame.
4. Grease the long portion of the new billet insert and push it into place. The long side of the insert slides through an air gap
in the bushing to the rear of the retaining bolt. Once installed the hole should be aligned with the original bolt hole. (There
is quite a bit of effort required to push the insert into its new location. Sometimes it is necessary to reach around the sub-
frame to the top side of the bushing and push down on the threaded portion of the factory bushing while pushing up on
the insert. When installing the insert the threaded portion of the factory bushing tries to twist, so you must keep it from
twisting.)
5. Re install the factory bolt and torque to 50 lbs. + an additional 90 degrees.
6. Carefully lower vehicle back onto the ground.
Before
After
During