AUTOTECH 10.297.200K-205K User manual

AUTOTECH
Installation Instructions
Phone [phone] Fax [phone]-E Paseo Adelanto, San Juan Capistrano, CA 92675
PART NUMBER: 10.297.200K, 201K, 202K, 203K, 204K, 205K
DESCRIPTION: AUTOTECH SPORTTUNED EXHAUST SYSTEM FOR A1 MODELS
As the removal and installation of the A1 exhaust system is a relatively simple one, the purpose of
this sheet will be to overview the procedure on how to perform a successful installation. Please read this
entire page before proceeding. Note: Always use gloves and eye protection when working with exhaust
system components.
1. Loosen, but do not remove left rear wheel lug nuts. Jack up left side of car and secure with
jackstands. Remove left rear wheel.
2. Apply some penetrating oil to the slip joints and clamp bolts of your old exhaust before disassembling
it. Wait a few hours for the penetrant to soak in and loosen up some of the rust. This will make
disassembly of your old exhaust much easier.
3. When installing the Autotech system, first lay out all the components on the ground to familiarize
yourself with their installed orientation. Start from the front pipe (that bolts or slips onto the catalytic
convertor) and work your way back, installing all components and clamps loosely so that you can
rotate the parts if necessary for proper fit and alignment.
4. Be sure to position the rear muffler so that the drain hole faces to the rear of the car.
NOTES:
a. On the Scirocco 16V exhaust, the muffler hanger is mounted so that the welded tube sits atop the
exhaust tubing.
Scirocco 16V Exhaust Layout
8V Rabbit, Scirocco, Jetta1
Exhaust Layout
Note: Hanger locations and styles will vary depending on model.
Tip styles will also vary depending on model.