Axi BA 1855 User manual

BA 1855
18.5” FIXED HD BUS MONITOR
INSTRUCTION MANUAL
SPECIFICATIONS
GENERAL
- Screen: 18.5” (47cm)
- Format: 16:9 Widescreen
- Resolution: 1366 x 768 HD
Supports 1080p
- Viewing Angle: 85° (L/R) 75/85° (U/D)
- Video System: PAL/NTSC Auto Switchable
- Image Adjustment: Brightness/Colour/Contrast/Saturation
- Mounting: Fixed - Wall or Roof
- Inputs: HDMI, 2 x RCA Video
- Housing: Robust Coated Metal
- Power Supply: 12/24 Volt DC (9-36V)
- Dimensions: 500(W) x 325(H) x 50(D)
- Included: Remote Control
Note: Battery NOT included

Installation steps:
1 Roof Mounting
1.1 First; please remove the metal mounting bracket, then use the supplied screws to fix the mounting bracket.
1.2 Run the monitor’s cable through the cable hole of the mounting bracket.(See figure 1)
1.3 Use the M6*14 screws to fix the monitor to the side of the mounting bracket. (See figure 1)
1.4 Connect the power cable as well as signal (video) cable.˄see figure” Machine Connection”)
2 Wall Mounting
2.1 First; please take off the mounting bracket, then use the M4.8 * 40 screw to fix mounting bracket.
2.2 Run the monitor’s cable through the cable hole of the mounting bracket.(See figure 1)
2.3 Use the M6*14 screws to fix the monitor to the side of the mounting bracket. (See figure 1)
2.4 Connect the power cable as well as signal (video) cable.
3Installation Notes:
3.1 Carefully handle the monitor so the surface is not scratched.
3.2 Make sure the installation position is flat to avoid distortion of the bracket.
3.3 All wiring connections must be insulated.
INSTRUCTIONS AND PRECAUTIONS:
ŸVoltage input: 12v-24v. Do not connect to 240v.
ŸKeep away from water and damp areas.
ŸDanger high voltage inside! Do not open housing.
ŸInstallation position must be strong enough to use the monitor in all
driving conditions.
ŸKeep away from the direct sunlight and other heat sources.
ŸImmediately turn off the power when an object or liquid falls into
the monitor. Contact a technician before use.
Ÿ'RQRW use sharp objects near the monitor surface.
ŸTurn off the power to clean; using a cotton ball or soft cloth
to wipe when there is dirt on the screen.
Do not use solvents.
Fi xat i on Hol e Cabl e Outlet Hole
Mountin
g
Cable Outlet
Figure1 Installation Diagram
INSTALLATION INSTRUCTIONS:

Please refer the below figure before wiring: (See figure 2˅
Power Wiring: This product can be used with DC12V-24V.
Connect the power cable (Red) to the vehicle’s positive power and earth cable (Black) to negative (See figure 2).
RCA Video input signal wiring: Connect the video cable from video source to the monitor’s video input jack.|
(See figure 2).
HDMI wiring: Change the channel you desire after connecting the HDMI lead (See figure 2)
Remote Control:
Used for power ON/OFF and selecting inputs- AV1, AV2, HDMI etc.
Please see other details on Figure 3 of remote control.
Battery not included.
Figure 2 Installation Diagram
Figure 3 Remote Control Diagram
Simple Faults Solution:
It may help to resolve some simple faults. If problem still exists, please contact us.
Faults Solutions
Monitor couldn’t be
turned on
1. Check whether the power cable is connected properly,
or reversed polarity.
2. Check that the power supply is working correctly.
Image is abnormal Check whether the video signal wire is connected
properly, and whether the video source works properly.

WARRANTY
Congratulations on your purchase of a quality Mobile Entertianment System! You’re joining
thousands of satisfied customers who enjoy & experience the benefits of the products we
distribute. In the unlikely event that some technical difficulty arises with your purchase, be
assured that we are most anxious to see that the problem is quickly rectified to your
satisfaction. Please familiarise yourself with the following simple conditions of our warranty.
This warranty covers faults through component failure or failure of the product to operate in
accordance with published specifications. Product failure as a result of unreasonable
environmental conditions, accident, misuse, improper installation, unauthorised repair, vehicle
electrical or wiring faults or neglect etc, will not be covered by this warranty. Removal and
installation costs, if any, would be paid by the owner as well as any freight or postage costs of
transporting the product to AudioXtra. AudioXtra shall not be liable or responsible for any loss
of use of this product or any form of consequential loss.
CONSUMER WARRANTY
This product is warranted by AudioXtra International Pty Ltd to be free from defects in
materials and workmanship under NORMAL USE for a period of TWENTY FOUR MONTHS
from the date of purchase.
WITHIN 30 DAYS OF PURCHASE DATE: Please return the unit for replacement to our
National Service Centre or the Retailer from where you made the purchase. All accessories
must be included. Proof of purchase date
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law.
You are entitled to a replacement or refund for a major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced
if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
must accompany the products.
AFTER 30 DAYS OF PURCHASE DATE: Warranty repair and service is carried out by our
National Service Centre. Repair and service will be carried out at no cost to the owner if proof
of ownership and the date of purchase can be verified to the satisfaction of the authorised
centre concerned with this repair. This proof should take the form of either:
a) The warranty card accompanying this product, stamped and dated by the dealer.
b) A Tax Invoice or Receipt showing full details of original vendor, purchaser, model
number and serial number.
COMMERCIAL WARRANTY: A product used in or associated with a commercial
application will carry a limited SIX MONTH warranty. An abnormal commercial application is
one where usage, dust, vibration, heat/cold and other environmental conditions exist at an
extreme level.
Model Number: Serial Number:
Dealer Name: Date of Purchase: / /
Dealer Address:
www.audioxtra.com.au
Purchaser’s Name:
Invoice/Sales Docket no:
Purchaser’s Address:
National Service Centre:
10 STODDART ROAD, PROSPECT, SYDNEY NSW 2148Australia
Telephone: [phone] Fax:[phone]
email:[email protected]
Please complete details below in the event of warranty service being required.
General Hints: To expedite service and prompt return of the equipment, please:
a) Clearly describe the fault in detail c) Include your return address
b) Safety and security pack the unit for transport d) Provide proof of purchase date as outlined above
AX
BA1855