Axi StreetCup150 User manual

User manual
Handleiding bewaren voor later gebruik
Keep instructions for later use
Anleitung zum späteren Gebrauch aufbewahren
Conserver la notice pour usage ultérieur
Guardar estas Instrucciones para su uso future
Conservare l’istruzioni per uso successivo
WARNING
WARNING
CHOKING HAZARD
small parts
Not suitable for children under
36 months
THE TOY IS TO BE ASSEMBLED BY
AN ADULT.
WARNING
Potential hazard description, e.g. In
unassembled state contain potentially
hazardous sharp points, so please
keep out of baby's reach
StreetCup150
A030.402.00
date: 10-2015www.axi.com [email protected]

StreetCup150
A030.402.00
2 PCS
1
1
1
2 PCS
2
2 PCS
3
22
3
3
2 PCS
1 PC
2 PCS
4
7
A2 PCS
4
4
6
5
7
AA
5
7
1 PC
6
date: 10-2015www.axi.com [email protected]

1. Sort out the different components from each other according to the picture above.
2. Assemble the base (4, 5, 6, 7) and then assemble the front part (1, 2) of the frame including
the crossbar and the L-bend pipes. The push buttons help in securing the pipes into position.
3. The back supports (3) must be assembled after step 2 has been completed.
4. The open end of back support ts into the pipe collar on the rear connectors welded on the
base of the goalpost. The top and front part of the back support must be secured with the L-bend
pipes using the bolt (A). The bolt can be tightened using an Allen Key (included in the kit).
5. Unfasten all the zippers and/or hook & loop connectors on the net.
The zipped sleeves are tted on the front crossbar and on the rear crossbar of the goalpost.
NOTE:If you are standing opposite the goalpost and facing it from the front, the print on the
net and on the top/front crossbar sleeve must be facing you. Invert the net if this is not the case.
6. The sleeves with hook and loop fasteners sewn on them
wraps around the 2x vertical side supports (on the front)
and the 2x horizontal side supports (on the base) respectively.
7. The Target Wall shall be secured on the front of the goalpost
by meshing the hook and loop fasteners on the wall with
the fasteners on the net.
8. The elastic loops wrap around the radius of the L-bent pipes
and then secured into place using the buttons.
The goalpost is now ready to use.
StreetCup150
A030.402.00
ASSEMBLY
1
1
22
3
3
4
4
6
5
7
AA
7
date: 10-2015www.axi.com [email protected]

StreetCup150
A030.402.00
1. This goalpost is made from Steel. Do NOT leave the goalpost in open after use because
moisture will lower the life of the goalpost . Avoid bringing the goalpost in contact with water,
moisture, dampness of any kind.
2. Store in a cool and dry place
3. Do NOT leave the goalpost unnecessarily exposed to UV rays and direct sunlight.
4. This goalpost is NOT a toy. Children under 10 years of age must only assemble under
the supervision of an adult.
5. The ground anchors can be dangerous for children. Exercise caution while using them!
The manufacturer or the seller are not liable for any complications arising from the misuse
of this product.
WARNING
1. Do NOT wash the goalpost. Only wipe clean with a dry cloth.
2. The net and Target wall must only be washed in lukewarm water and a regular soap.
3. Drip dry in shade only.
4. Avoid contact with any corrosive liquids or substances such as water, salt water, fuel, kerosene,
etc at. all times. Oils and such chemicals can damage the net and reduce their life signicantly.
CLEANING AND DRYING
1. Store in a cool and dry place, away from sunlight and dampness. Damp environment may
lead to development of mold on the net and Target Wall.
2. Always carry around in its bag. Make sure that the sharp end of the anchors are covered with
the rubber cap. Not doing so may damage the bag, other components inside the bag as well
as anything surrounding the goalpost.
3. Secure the pipes in such a way that they do not move or rub against each other.
STORAGE AND TRANSPORT
date: 10-2015www.axi.com [email protected]