Badeloft AT-04 User manual

Badeloft®
Freestanding Faucet
Installation Guide AT-04

Badeloft®
Freestanding Faucet
Installation Guide AT-04
Notice:
1. Only use soft a fabric cloth to clean the faucet. No acid or alkaline cleaning solutions should be used
because it can damage the nish.
2. The cartridge and diverter are tested in the factory, please don‘t try to disassemble, as these are not
user serviceable parts.
3. The plumbing under the surface should be tested for at least 30 min. under a 0.8 Mpa pressure
before installing the tile to check for leaks.
4. The pipes under the surface should be installed as directed in the installation guide. Please do not
exchange the hot and cold water as this could cause damage to the faucet.
5. The pipes must be ushed to clean out debris before the installation of the tap. If this step is
ommited the impurities could destroy the cartridge, diverter, and aerator and render the faucet defective.
7. Use CAUTION when open turning on the tap. Turn on the cold rst then add the hot to create a
suitable tempeture.
8. Gloves are recommended for the installation, as some of the part could be sharp.
Troubleshooting:
1. If the water ow is too low make sure the main supply valves are opened up all the way.
2. If the water coming out of the tap is irregular please check the aerator and clean it for debris.

Badeloft®
Freestanding Faucet
Installation Guide AT-04

Badeloft®
Freestanding Faucet
Installation Guide AT-04

Badeloft®
Freestanding Faucet
Installation Guide AT-04

Badeloft®
Freestanding Faucet
Installation Guide AT-04

Badeloft®
Freestanding Faucet
Installation Guide AT-04

Badeloft®
Freestanding Faucet
Installation Guide AT-04

Badeloft®
Freestanding Faucet
Installation Guide AT-04

Badeloft®
Freestanding Faucet
Installation Guide AT-04