Balance 69760 User manual

HD Rehab AB, Tryffelslingan 4, 181 57 Lidingö, Sweden
tel. [phone] [e-mail] www.hdrehab.se
MD
Intended use
The IV pole and mounting bracket are intended to be used with HD Balance. Using an IV pole with the wheelchair
can make it easier for the user to be more mobile for certain types of treatments or examinations.
IV Pole and Mounting bracket are ordered separately. Note that neither product is intended to be used with
equipment from other manufacturers.
Parts included (IV pole) Parts included (Mounting bracket)
Assembly of Mounting bracket
Screw the mounting
bracket in place on
the back frame tube
with the included
screws and washers.
IV Pole and Mounting bracket
Art. nr. 69760 and 69755-1 / 69755-2 Doc. nr. 96821-1 Rev E 2022-02_23
User manual /
Assembly instructions
Page 1 (2)
1 x IV hook
1 x screw M5x14
1 x mounting bracket
(LH model shown)
1 x IV pole
11

Assembly of IV Pole
Push the hook into the top bushing. Note the alignment of the hole.
Attach the hook in place with the screw.
Lower the pole through the mounting bracket to the desired height.
Tighten the clamp using the knob (a).
Loosen the knob (c) and adjust the inner pole to the desired height. Tighten the knob.
When the wheelchair is tilted the angle of the IV pole can be adjusted to a vertical
position using the front knob (b, seen in step 4).
Use and Care instructions
• Make sure that problems or risks do not occur when the wheelchair adjustments are used. The IV pole
entails increased risk of tipping, especially in a tilted position with heavy drip bags. Attention must be paid.
• Make sure the knobs are tightened before use, otherwise the IV pole can fall forward or backward.
• Always keep the IV pole as vertical as possible. Use the front knob (b) to adjust the angle.
• Always use tip protectors.
• IV pole should not be used together with the Bag Hook accessory.
• Maximum total weight for the IV pole together with drip bags is 6 kg.
• Always replace damaged parts immediately. For more information see Maintenance Instructions,
document number 96730-1.
Page 2 (2)
User manual/Assembly instructions - IV Pole
4
2
1
5
3
6
b
a
c
3
4
1
5
2
6