baridi DH57 User manual

Baridi 25L Mini Bar/Fridge, Lock & Key,
LED Light, Ultra Quiet, Energy Class G
Model No. DH57
Thank you for purchasing a Baridi product from the Dellonda range. Manufactured to a high standard,
this product will, if used according to these instructions, and properly maintained, give you years of
trouble free performance.
DH57 Issue 4 28/09/2021

2
Important Information
Please read these instructions carefully and note any safe operational requirements, warnings &
cautions. Use the product correctly and with care for the purpose for which it is intended. Failure
to do so may cause damage and/or personal injury and will invalidate the warranty. Keep these
instructions safe for future use.
• ELECTRICAL SAFETY
• WARNING! It is the user’s responsibility to
check the following:
• Check all electrical equipment and appliances
to ensure that they are safe before using.
Inspect power supply leads, plugs and all
electrical connections for wear and damage.
Dellonda recommend that an RCD (Residual
Current Device) is used with all electrical
appliances.
You may obtain an RCD by contacting your
local domestic stockist. If the product is used
in the course of business duties, it must be
maintained in a safe condition and routinely
PAT (Portable Appliance Test) tested.
• Electrical safety information: It is important
that the following information is read and
understood.
• Ensure that the insulation on all cables and on
the appliance is safe before connecting it
to the power supply.
• Regularly inspect power supply cables and
plugs for wear or damage and check all
connections to ensure that they are secure.
• Important: Ensure that the voltage rating on
the appliance suits the power supply to be
used and that the plug is tted with the correct
fuse - see fuse rating in these instructions.
• DO NOT pull or carry the appliance by the
power cable.
• DO NOT pull the plug from the socket by the
cable.
• DO NOT use worn or damaged cables, plugs or
connectors.
• Ensure that any faulty item is repaired or
replaced immediately by a qualied electrician.
• This product is tted with a BS1363/A 13 Amp
3 pin plug. If the cable or plug is damaged
during use, switch off the electricity supply
iiii and remove from use. Ensure that repairs are
carried out by a qualied electrician.
• Replace a damaged plug with a BS1363/A 13
amp 3 pin plug. If in doubt contact a qualied
electrician.
•
A) Connect the GREEN/YELLOW
earth wire to the earth terminal ‘E’.
B) Connect the BROWN live wire to the
live terminal ‘L’.
C) Connect the BLUE neutral wire to
the neutral terminal ‘N’.
• Ensure that the cable outer sheath extends
inside the cable restraint and that the restraint
is tight.
• Dellonda recommend that repairs are carried
out by a qualied electrician.
• GENERAL SAFETY
• DO NOT store explosive substances such as
aerosol cans with a ammable propellant in
this appliance.
• WARNING: Ensure the supply cord is not
trapped or damaged.
• WARNING: DO NOT locate multiple portable
socket-outlets or portable power supplies at
the rear of the appliance.
Replacement fuse rating:
13A
Refer to
instructions
Indoor use
only
Warning:
ammable
material

3
• This appliance is intended to be used in
household and similar applications such as
staff kitchen areas in shops, ofces and other
working environments; holiday homes, hotels
and other residential settings; and catering
and similar non-retail applications.
• This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of knowledge and
experience if they have been given supervision
or instruction concerning the use of the
appliance in a safe way and understand the
hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance
shall not be made by children without
supervision.
• INTRODUCTION
• Premier 25 litre capacity mini fridge. Uses
advanced thermoelectric cooling and heat
pipe technology to give a temperature range
of 5-15°C. Built-in thermostat to control
temperature to user’s preference. Noise rating
of 23dB makes this mini fridge suitable for
use in bedrooms, hotel rooms, guesthouses,
B&B and the ofce. Automatic defrost feature
tted to make using this device as easy and
convenient as possible. Design features
removable wire shelves, internal LED light and
built in security lock. Fitted with a reversible
door and adjustable feet to make it even easier
to t in any space. Energy Efciency Class: G.
• SPECIFICATION
• Model no: DH57
• Temperature range: 5-15°C
• Power Rating: 58W
• Voltage: 220-240V
• Frequency: 50Hz
• Energy efciency class: G
• Noise level: 23dB
• Dimensions (W x D x H): 380 x 380 x 475mm
• Volume:23L
• INSTALLATION
• The unit is designed to be free-standing.
Ventilation Space - a minimum space of
50mm is required underneath the fridge and
20mm minimum for all other surfaces. This
will maximise the efciency, performance and
the life of the fridge and also ensure that there
is sufcient space for the hinge to operate
effectively.
• Locate the unit away from direct sunlight or
sources of heat i.e. radiator, stove etc. Extreme
or cold ambient temperatures may also
prevent the unit working effectively.
• We recommend that the minimum ambient
temperature of the room that this appliance
is used does not drop below 12°C. If the
temperature exceeds 25°C the fridge will take
a minimum of 3.5 hours to reach 12°C.
• DO NOT locate the unit in a damp or moist
location.
• Ensure that the oor surface is strong and
stable enough to support the unit when it is
fully loaded.
• Level the unit when in location by using the
adjustable levelling feet.
• Once in position allow the unit to rest for an
hour before turning it on.
• Allow the unit 2-3 hours to reach set
temperature after switching on before placing
any items in the compartment.
• The unit is capable of having the door opening
changed.
• To change door opening, carefully remove the
door upper and lower hinge caps using a at
blade.
• Loosen the cross head screws, remove the
hinge and lift off door.
• Remove lower hinge bracket and replace with
front foot from the other side.
• Remove hinge hole plug and place into
opposite side.
• Loosely x the lower hinge bracket to its new
position and carefully locate door in place.
• Loosely x upper hinge in place.
• Check that the door is properly closed, sealed
and level before tightening all screws.
• OPERATION
• The ‘ON/OFF’ switch is located inside the
fridge in the centre of the light (Fig. 1).
Fig. 1

Dellonda Limited, Sole UK Distributor of Baridi
Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757575 [email protected] www.dellonda.co.uk
Environment Protection, Waste Electrical and Waste
Electronic Equipment Regulations (WEEE)
Recycle unwanted packaging materials. When this product is no longer required, or has
reached the end of its useful life, please dispose of in an environmentally friendly way.
Drain any uids (if applicable) into approved containers, in accordance with local waste
regulations. It is our policy to continually improve products and we reserve the right to alter
data, specications and parts without prior notice. No liability is accepted for incorrect use
of this product. Guarantee is 12 months from purchase date, proof of which is required for
any claim.
Symptom Solution
Unit does not operate. Not plugged in.
Fuse/circuit breaker failure.
Turns on and off frequently.
Poor cooling.
Room temperature higher than normal.
Door opened too often.
Door not properly closed.
Temperature control incorrectly set.
Door gasket not sealing.
Not enough space around unit.
Vibrations Check to assure unit is level.
Light does not work Not plugged in / turned on.
Fuse/circuit breaker failure.
LED light expired
Door will not close properly Unit not level.
Gasket distorted.
Internals out of position.
Door not properly installed after re-tting.
• It shows settings 0-1-2-3 with ‘0’ being OFF
and ‘3’ creating maximum cooling.
• To turn the unit on, rotate control knob from
the ‘0’ position.
• A setting of ‘3’ will create maximum cooling
effect (approx. 50C) and ‘1’ will set the working
internal temperature at approximately 150C.
• When the set temperature is reached, the
compressor will power off automatically.
• On rst use, set the temperature to maximum
e.g. ‘3’ and adjust to suit once this is reached.
• Please see Fig.1.
• Troubleshooting
• MAINTENANCE
• Remove the power plug from the supply when
performing cleaning or maintenance.
• DO NOT use abrasive or chemical cleaning
materials on any surface of the unit.
• Wipe interior and exterior surfaces with a
damp cloth and dry thoroughly with a clean
dry cloth.
• For more soiled surfaces use a neutral
detergent, wipe down with a clean damp cloth
and dry thoroughly with a clean dry cloth