Basalte ASANO A4 User manual

Installation Manual
ASANO A4
© 2019 basalte v1.0
Before operating the unit, please read this
manual thoroughly and retain it for future
reference.
Model No. 0702-04
Caution: any changes or modifications not
expressly approved in this manual could void
your authority to operate this equipment.
Description
Asano A4 is a networked 4-zone stereo output module that allows connecting up to 4 zones of third party amplifiers
or active speakers with the Asano system. Every zone has a separate trigger output to switch on and o the external
amplifier or active speaker. Asano A4 is able to connect three analogue input sources.
A4 can only be used in combination with S4 and is fully controlled over the audio network. The S4’s integrated KNX
control allows you to integrate the Asano A4 in a KNX system.
1 4a 6a4b 6b4c 5a 6c 6d3
5b
2
1Power supply
2USB - only for service
3Audio network
4Analogue input
aSource 1
bSource 2
c Source 3
5 Trigger output
aZone 1 - 2
b Zone 3 - 4
6Analogue output
aSource 1
bSource 2
c Source 3
dSource 4
LED feedback
The Asano A4 front panel has a feedback LED which indicates following statuses:
• Blue: standby mode
• White: at least one output zone amplifier is active
• Following status indicates a possible device failure:
- Red flashing
- Purple flashing
- Cyan flashing
+ - + -
+ - + -

Installation Manual
ASANO A4
© 2019 basalte v1.0
How to install
- Power supply (1)
The Asano A4 has to be powered by a Euro mains power lead with a 230V AC input.
Do not unplug the connector at this side with voltage present.
- Audio Network (3)
Connect Asano A4 to the audio network using Ethernet CAT5e cable. The network has to be a dedicated network
separated from your local data network.
- Inputs (4)
Additional sources can be connected to the 3 analogue inputs.
- Trigger output (5)
Each zone has a seperate trigger output to switch on and of the amplifier or active speaker.
- Loudspeaker outputs (6)
The 4 analogue zones are connected with RCA connectors.
basalte bvba | hundelgemsesteenweg 1A | 9820 merelbeke | belgium
t [phone] | f [phone] | www.basalte.be | [e-mail]
1 4a 6a4b 6b4c 5a 6c 6d3
5b
2
Technical data
Power: 220V - 240 V AC
Power consumption: 5W
Analogue input sensitivity: 2V RMS
Ambient temperature:
Operation: -5°C to 45°C
Storage: -15°C to 55°C
Transport: -15°C to 55°C
Dimensions: w 330 x h 50 x d 180 mm
Weight: 1,5 kg
Max. humidity: 93% relative humidity,
no moisture condensation
Protection class: II
Type of protection: IP 20
Certification: CE
+ - + -
+ - + -