Advantech PCM-27J3AU Installation and operation manual

STARTUP MANUAL
1 Startup Manual
PCM-27J3AU
3-Port Audio Stereo, mPCIe, 3.5mm Jack
Packing List
Before installation, please make sure that you have:
1 x Audio mPCIe Card
1 x 3-Port Audio I/O plate with iDoor bracket
1 x Wired signal cable
1 x Startup Manual
1 x Warranty Card
If anything is missing or damaged, contact your distributor
or sales representative immediately.
Installation
Notes
For more information on this and other Advantech
products, visit our websites at:
http://www.advantech.com
http://www.advantech.com/eAutomation
For technical support and service:
http://www.advantech.com.tw/eservice
This manual is for PCM-27J3AU
Part No: 200327J300 1st Edition
December 2015
PIN Assignment of Audio Signal Connector
(14-Pin)
Documentation/Software Support Guide
PCM Module with iDoor technology supports following
iAutomation Computing Platforms:
Embedded Automation PC UNO-2200/2300 series
Control DIN-Rail PC UNO-1300/1400 series
Control Cabinet PC UNO-3200/3300/3400 series
Control Panel Computers TPC-xx81/xx82 series
Thin Client Panel Computers TPC-xx51 series
See the following page for installation in TPC Embedded
Panel Computers and UNO Embedded Computers.
The Startup Manual is included in the package. The other
support documentation such as datasheets can be accessed
from Advantech's website.
Description of PIN Use - I/O Board CN2 / mPCIe Card CN1
Pin1 LOUT_R Pin2 LOUT_L
Pin3 LOUT_JD Pin4 GND_AUD
Pin5 LIN_R Pin6 LIN_L
Pin7 LIN_JD Pin8 GND_AUD
Pin9 MIC_R Pin10 MIC_L
Pin11 MIC_JD Pin12 GND_AUD
Pin13 GND_AUD Pin14 NC

Startup Manual 2
TPC Embedded Panel Computer Installation
1. Remove the screws from the backplate and lift
it off.
UNO Embedded Computer Installation
1. Remove the screws from the base plate and
lift to remove.
2. Insert the mini-PCIe card and secure the screws
3. Remove the screws to remove the blanking
plate.
2. Remove the blanking plate screws and the
blanking plate.
3. Insert the PCM Module through the
blanking plate slot.
4. Secure the PCM Module with the screws you
removed from the blanking plate.
4. Insert the PCM Module through the blanking
plate hole and secure the screws. Attach the
PCM Module to the mini-PCIe card with the
cable.