5019 412 10022
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in
the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the Energy Label refer to the programme Cotton 60° C.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump
drains the water out.
1. Load the machine, close the drum flaps and
check that they are properly locked.
2. Add detergents and additives into the
dispenser to no more than the
MAX level
mark, as follows:
3. Turn the
programme selector knob
to the
desired programme.
4. Turn the
temperature selector knob
to
the desired temperature.
5. Press the
spin speed reduction
button,
if
desired.
Selecting or deselecting an option can be
done at any time during the programme.
The option will be applied as long as the
corresponding programme phase has not
been executed yet.
Eco button
The duration of the wash is extended and
the max temperaturereduced to save up to
40% of energy compared to a normal wash
but maintaining good washing results.
Half Load button
Can be used for small loads and lightly
soiled laundry.
Reduces the water consumption especially
during the rinses.
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 95 5.0 63* 1.80 2:05
Cotton 60 5.0 55 0.95 2:05
Cotton 40 5.0 55 0.55 2:05
Synthetic 60 2.0 56 0.80 1:30
Synthetic 40 2.0 56 0.40 1:30
Delicate 40 1.5 60 0.55 0:45
Wool 40 1.0 60 0.50 0:40
Handwash 30 1.0 60 0.30 0:50
PREPAR ATIO N OF WASH CYCLE
Programme with pre and main
wash
Main wash programme without
prewash
Fabric softeners and
conditioners
Chlorine bleach
(4 chamber models only)
Stain remover agents
Anti-scale agents
(if necessary)
SELECT THE DESIRED OPTION
Turn on the tap and press the
On/Off
button. The indicator light of the
On/Off
button lights up.
Note
: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where
it was interrupted.
The programme selector knob is in the Stop
position .
1. Press the
On/Off
button to switch off
the machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the door to unlock (about
1minute).
5. Open the door and the drum flaps and
unload the machine.
1. Switch off the machine by pressing the
On/Off
button.
2. Select the new programme.
3. Start programme by pressing the
On/Off
button again.
If, for any reason, you wish to interrupt the
programme for a certain time and continue it
later:
1. Press the
On/Off
button.
2. After the desired pause, press again the
On/O ff button.
1. Switch off the machine by pressing the
On/Off
button.
2. Set the programme selector to Drain .
3. Press the
On/Off
button again to start
the Drain programme.
PROGRAMME START
END OF WASH CYCLE
CHANGE THE PROGRAMME DURING THE
WASH CYCLE
PAUSE/INTERRUPT A PROGRAMME
CANCEL PROGRAMME
