BCP SKY4728 User manual

User Manual
Safety Precautions
Disassembly and installation of this speaker cabinet must be carried out by qualified personnel
following the approved safety standards.
Do not attempt to clean the plastic enclosure with solvents or petrochemical based cleaners.
Do not place objects which are sources of heat on the speaker cabinet such as lighting equipment
or smoke machines.
Do not expose the speaker cabinet to direct rain or allow it to stand in water. Liquid getting into
the box is hazardous and will risk a short circuit.
Do not stack the speaker cabinet in a manner that could cause injury should it become
dislodged.
Before installation, ensure that the voltage and frequency of power outlet match the power
requirements of the speaker.
Disconnect from main power before making connections to the speaker.
Make sure that the power cord is never crimped or damaged by sharp edges.
Never let the power cord come into contact with other cables. Only handle the power-cord
by the plug.
If the fuse need to be replaced, it must be replaced with the identical rate and dimensions.
Product Name:SPEAKER
Brand name:BCP
Model name: SKY4728
Manufacture: TONOCH ELECTRONICS LIMITED

Attention
Before connecting or operating your speaker, study the accompanying instruction manual and be aware
of the operating precautions and wiring procedure.
WARNING:
1. Do not mix alkaline, standard (carbon-zinc), and rechargeable (nickel hydride) batteries.
2. Do not mix old and new batteries.
3. Non-rechargeable batteries should not be charged.
4. Rechargeable batteries should be charged under adult supervision only.
5. Exhausted batteries should be removed.
6. The supply terminals should not be short-circuited.
7. Do not put batteries next to or in a heat source (fire, electronic heating device, etc.).
8. Do not hit batteries against hard objects.
9. Do not submerge batteries in water.
10. Batteries should be inserted with the correct polarity.
WARNING:
Manufacturer and seller expressly disclaim any and all liability for personal injury, property
damage or loss, whether direct, indirect, or incidental, resulting from the incorrect attachment,
improper use, inadequate maintenance, or neglect of this product.
E-MAIL US:
We’re here 7 days a week to help you!
[e-mail]
This symbol on the product or on its packaging indicates that
this product shall not be treated as household waste. Instead it
shall be handed over to the applicable collection point for the
recycling of electrical equipment. By ensuring this product is
disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of
this product. The recycling of materials will help to conserve
natural resources. For more detailed information about
recycling of this product, please contact your local city office,
your household waste disposal service, or the shop where you
purchased the product.

Functions
1. Media Player
2. Volume1 : Control the Volume of Microphone input
3. 6.35 MM Jack input
4. XLR for Mic input
5. Wireless MIC volume control
6. Volume 2 : Control the Volume of line in
7. MP3 Volume: Control the volume of MP3
8. MASTER Volme:Control the master volume
9. AUX input
10. Equalizer : Control the tone level of high frequency at range -12dB to + 12dB.
11. Equalizer: Control the tone level of low frequency at range -12dB to + 12dB.
12. RCA connector to control Line input, RCA right channel input, and RCA left channel input
13. XLR connector to control Line input: Allows you to connect an external audio device (CD,
radio ,DVD ,etc.), with an adaptor
14. XLR connector to control Line out: Connect other amplifier or even another powered speaker
cabinet in cascade
15. Main supply inlet: Connects the main power cable
16. Power On/Off Switch
17. Speaker out: Connect with a passive speaker
Remote Control
Use the remote control to operate the media player.
The numbers are the remote control can be used to play corresponding numbered songs on the
USB drive or SD card.
MODE
Toggle between USB / SD / BLUETOOTH
Play/Pause
Repeat
Last
Next

FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.