Bebe style EZ 123 User manual

Compact Highchair
Instructions
IMPORTANT! KEEP FOR
FUTURE REFERENCE

1
Welcome
Page 1
The Compact highchair is carefully designed for baby’s safety and features a large
tray with cup holder and a wipe clean seat with five point harness. The highchair
also folds compactly for storage.
Suitable for children who are able to sit up unaided (approximately 6-9 months up
to 36 months).
To ensure safe, trouble free use, please take a little time to read the important
safety notes below and the following instructions.
2 Safety notes
•WARNING! Do not use the highchair until your child can sit up unaided (6-9
months approximately).
•WARNING! Do not leave the child unattended.
•WARNING! Ensure your child wears a correctly fitted and adjusted harness at all
times. For extra safety, D-rings are provided for a separate harness approved to
BS EN 13210.
•WARNING! Do not use the highchair unless all components are correctly fitted
and adjusted.
•WARNING! Be aware of the risk of open fires or other strong sources of heat, such
as electric bar fires, gas fires etc. in the vicinity of the highchair.
•WARNING! Do not use if any part is broken, torn or missing.
•WARNING! Do not move the highchair with your child inside.
•Use only on a level and stable surface.
•When using the highchair at a table, ensure your child cannot push against the
table or another surface as this could result in the chair tipping.
•Never move or carry the highchair whilst the baby is in it.
•Ensure children are clear of all moving parts before making any adjustments.
•Do not use near stairs or steps.
•When not in use, store away from children.
•Designed and manufactured to BS EN 14988 : 2006.

Page 2
3
Parts
I
Please retain all packaging until you are certain no parts are missing.
After assembly, please dispose of all packaging carefully, including the
caps on the ends of the legs.
Seat frame,
seat & harness
Back frame
Front legs
(wider at top)
Rear legs
(narrower at top)

Page 3
4
Tube
fittings
B
A
The backrest frame and legs attach using
the system shown left.
The silver button A is squeezed and the
tube end inserted into the outer tube until
the silver button appears through the
corresponding hole, A.
5 Fitting the seat
Fit the backrest tube to the seat frame as
described above.
Open the seat frame.
Slide the pocket of the seat back over the
curved back frame.
Fasten the press stud A at each side of
the seat.
Secure the seat sides by wrapping them
around the frame and fastening press
studs B at each side of the seat.
A
B

Page 4
6
Opening
Open the seat frame fully and press the
tray down firmly to fasten the clips to the
tube underneath.
Wrap the webbing strap around both
tubes under the tray and fasten the press
stud A.
A
7 Fitting the legs
B Noting the front legs are wider at the top
than the rear legs, press the silver buttons
B on the legs in and push the legs on to the
A frame tubes A.
Repeat for the narrower rear legs that fit
on frame tubes B.
A

Page 5
8
Attaching
and
checking
the
harness
The harness comes part fitted to the seat.
Ensure the waist straps and crutch strap
are fed through the slots in the seat unit.
The shoulder straps are pre-fitted but can
be height adjusted by pulling the straps
through the slots in the seat and re-
inserting through the preferred slots.
With the highchair upturned, wrap the
split metal rings at the end of each strap
around the corresponding support bars
and thread the webbing through the
A small gap in the metal ring, A, so it is
attached as in B.
Once attached, check the security of the
waist and crutch straps by pulling on them
from the front of the seat.
B
9 Harness use
A five-point safety harness is provided to
A A restrain your child and should always be
worn.
Sliding adjusters, A, are fitted and should
be carefully adjusted so the harness fits
your child comfortably.
To fasten the harness push the side pieces
A
A into the centre buckle.
To release, press parts B and remove from
A the buckle.
B
B ‘D’ rings are fitted at the end of each
waist strap should you wish to attach a
separate harness complying with BS EN
13210.

Page 6
10
Folding
Release the press stud, A on the webbing
strap underneath the tray, lift the tray
firmly to release the clips from the tube,
and fold the legs together.
A
11 Care of your highchair
•Wipe spilled food off the highchair as soon as possible as some types of food may
cause staining.
•The seat pad can be cleaned by sponging with warm soapy water and a mild
detergent. A mild disinfectant may be used. Never clean with abrasive, ammonia
based, bleach based or spirit type cleaners.
•Regularly check the highchair, particularly the harness for wear and discontinue
use if damaged

Page 7
10
Folding