Becker TRAFFIC ASSIST HIGHSPEED User manual

Operating instructions GB

1
Index
The Traffic Assist Highspeed 6
Operating guide content 6
Use 6
Navigation 6
Music 7
Pictures 7
Unpacking the Traffic Assist
Highspeed 7
Checking the delivery 7
Delivery contents 7
Complaints procedure 8
Handling the packaging 8
Description of unit 8
Traffic Assist Highspeed - basic unit 8
Cable for power supply from
cigarette lighter 9
Battery 9
SD memory card 9
USB connection cable 9
Unit bracket 9
Accessories 10
Mains power supply unit 10
External GPS antenna 10
Headset 10
Information about
documentation 10
Quick start guide 10
Operating instructions 10
Registration 11
Repairs 11
Disposal 11
Emissions 11
Overview Traffic Assist
Highspeed 12
Maintenance and care 16
Battery quality declaration 17
Display quality declaration 17
Start-up 17
Memory card 17
Inserting memory card 18
Ejecting memory card 18
Power supply 19
Using the battery 19
Connecting to socket 19
Connecting up to power supply 19
Removing power supply 19
Connecting to the cigarette lighter 20
TMC antenna* 20
GPS-antenna 20
Unit antenna 20
Connecting up external
antenna 21
Switching the Traffic Assist
Highspeed on/off 21
Switching on 21
Switching off 22
Unit bracket 22
Fitting the unit bracket 23
On the windscreen 23
On the dashboard 23
Adjusting the unit bracket 24
Vertical movements 24
Horizontal movements 24
Adding the Traffic Assist Highspeed 24
Basic information about the
touch screen 25
Operation 25
Calibration 25
Basic information about the menus 25
The main menu 25
Entries made with the entry menu 25
Entering characters 26
Adopting suggestions 26
Scrolling through the lists 26
Special characters and umlauts 27
Entering numbers 27
Deleting characters 27
Inserting spaces 27
The back key 28
More maps 28
Map loaded 28
Installation program 28
Transferring files 28
Transferring using the SD card reader 28
Transferring using the USB port 29
Transferring maps 29
Transferring pieces of music and
pictures 29
Faults 30
*Applies only to the Traffic Assist Highspeed II

2
Index
Navigational mode 31
What is navigation? 31
Selecting navigation 32
Aids for navigation 32
Rapid access 32
Navigation menu 32
Map display 32
Rapid access 32
Structure of rapid access 33
Navigation menu and map display 33
The list of destinations 33
Icons used 33
Operating rapid access 34
Starting using an existing
destination 34
Scrolling in the destinations
memory 34
Displaying or editing destination 34
Change to map display 35
Displaying current position 35
Calling up Navigation menu 35
TheNavigation menu 35
Structure of the navigation menu 36
Address 36
Point of interest 36
Select on map 36
Route planning 36
Settings 36
Navigation menu: Address 36
Selecting a country 37
Select address and start 37
Stopping navigation 41
Navigation menu: Point of interest 42
Point of interest: Near GPS
position 42
Point of interest: nationwide 43
Navigation menu: Select on map 44
Navigation menu: Route planning 45
Route list 45
Scrolling through the list of routes 45
Using a route 46
The New route button 46
The Edit key 47
The Calculate key 47
The Start key 48
Navigation menu: Settings 48
The button GPS 49
The Map info key 49
The Route info key 49
The Signpost info key 50
The Routing options key 50
The Volume key 51
The Speed key 52
The Automode key 53
The TMC button* 54
The Route planning key 54
The Time Zone key 55
The button Load map 55
The Format key 55
The Factory settings key 56
The Smart Speller button 56
What is dynamic route guidance?* 56
Displaying TMC messages on
the map* 57
Using TMC* 57
Updating the announcement list* 58
Taking announcements into
consideration when calculating
routes* 58
Automatic recalculation* 58
Manual recalculation* 58
Map display 59
Map layout 59
Map display without driving
guidance 59
Map display with driving guidance 60
Map display with toolbar 60
Using the map display 61
Repeat the last voice prompt 61
Setting announcement/music
volume 61
Information rows 62
Zooming and the map (toolbar) 62
Display route (toolbar) 62
Position and display mode
(toolbar) 62
Displaying TMC messages
(toolbar)* 63
Daytime - Night-time design
(toolbar) 63
Change display (toolbar) 64
Point northwards (toolbar) 64
*Applies only to the Traffic Assist Highspeed II

3
Index
Move map (toolbar) 64
Call Options menu 65
Position information (toolbar) 66
Playback of MP3 files during
an active navigation 66
Music operations 67
Selecting music playback 67
The MP3 player 67
Operating the MP3-Players 68
Track skip 68
Play 68
Pause 68
Folder overview 69
Opening the next folder 69
Repeat current track 69
Setting volume 70
Navigation during MP3 player
operation 70
Shutting down the MP3-Player 70
Pictures mode 71
Selecting pictures display 71
The Picture Viewer 71
Operating the Picture Viewers 71
Scrolling 71
Slideshow 71
Full screen 72
Shutting down the Picture Viewer 72
Folder viewing mode 72
Operating folder viewing mode 73
Subfolders 73
Scrolling 73
Selecting a picture 73
Changing folder levels 73
Closing folder viewing mode 73
Adjusting the music volume 73
Settings 74
Selecting the settings 74
The setting menu 74
Operation 74
Selection possibilities 74
Closing the setting menu 74
The individual menu points 74
Energy 74
Displaying the energy supply 74
Ending the status display 75
Brightness 75
Calibration 75
Starting calibration 75
Language 76
Calling up language selection 76
Turn the page 76
Selecting the language 76
Cancelling the language selection 76
Moodlight 76
Information 77
Specialist words 78
Keywords 80
Technical Data 82
FACT SHEET 83
The information contained herein may
be changed at any time without prior no-
tification. This manual nor any parts the-
reof may not be reproduced for any
purpose whatsoever without the express
written consent of HARMAN/BECKER
Automotive Systems GmbH.
© Copyright 2006, HARMAN/
BECKER Automotive Systems GmbH
All rights reserved.
*Applies only to the Traffic Assist Highspeed II

4
!Safety information
• The unit may only be operated if the traffic situation allows for this and if you are absolutely certain that you
yourself, your fellow passengers or other road users will not be put at risk, encumbered or disturbed by this.
• The rules of applicable road traffic acts must be observed at all times. Destinations may only be input when the
vehicle is stationary.
• The navigational system is only an aid. The data/details provided may in some cases be incorrect. The driver must
always decide whether to follow the details given or not. We accept no liability for the navigational system issuing
incorrect details. As a result of traffic routing changes and deviating data, inaccurate or incorrect instructions
may be given. Drivers should always pay attention to the actual road signs and traffic control. In particular, the
navigational system cannot be used as a means of orientation in cases of poor visibility.
• The unit may only be used for its intended purpose. The volume of the Navigationsgerätes should be set so that
noises outside the vehicle can still be heard.
• The unit should be switched off immediately if faults occur (e.g. development of smoke or smells).
• For safety reasons, the unit may only be opened by a specialist. Please contact your local stockist if you require
repairs.

5
• The SD memory card can be removed. Caution! Small children could swallow it.
• The mains voltages (V) indicated on the mains charger, the car charger adapter and the unit must not be
exceeded. Failure to observe this can result in destruction of the unit and the charger as well as explosion of the
rechargeable battery.
• Never open the unit or the rechargeable battery. Any modification to the unit is also impermissible and renders
the type approval invalid.
• Use only genuine BECKER original accessories. This will ensure that all the relevant regulations are complied
with and damage to health and property is avoided. Dispose of defective units and the rechargeable battery
according to the applicable legal requirements.
• No warranty is granted in the case of improper use. These safety instructions also apply to genuine BECKER
original accessories.

6
The Traffic Assist Highspeed
The Traffic Assist Highspeed
Operating guide content
The two devices Traffic Assist High-
speed and Traffic Assist Highspeed II
are described in this operating guide. All
the descriptions, with the exception of
those marked with an asterisk (*), apply
to both devices.
The sections of the operating guide
marked with an asterisk (*) apply specif-
ically to the Traffic Assist Highspeed II.
Use
The Traffic Assist Highspeed is a po-
werful PND (Personal Navigation De-
vice) for use in vehicles and closed
spaces. The unit should be protected
from dampness and dirt.
The Traffic Assist Highspeed can be
used as:
• navigational unit
• MP3 (device for playing music)
• JPEG picture viewer
Navigation
Thanks to GPS = Global Positioning
System, you no longer need to spend
hours searching through road atlases.
Once outside buildings, the receiver an-
tenna integrated in the unit gives you
continuous access to navigational possi-
bilities. Depending on reception, you
may not be able to use the navigational
function inside buildings. When used in
vehicles, you may not be able to adequa-
tely receive GPS data depending on how
the Traffic Assist Highspeed is installed.
In such cases, you will have to connect
up an external antenna (does not fall
within the scope of supply).
The Traffic Assist Highspeed II is equip-
ped with TMC*, which gives you the op-
tion of receiving traffic announcements
via the TMC antenna provided. Traffic
announcements are transmitted when
the TMC is active. The system plans an
alternative route automatically or on re-
quest to avoid traffic problems, depen-
ding on the setting.
3012
*Applies only to the Traffic Assist Highspeed II

7
The Traffic Assist Highspeed
Music
Thanks to the integrated MP3-Player,
you can listen to your favourite tracks
when on the go.
Pictures
The Traffic Assist Highspeed has a Pic-
ture Viewer offering many functions for
viewing pictures.
Unpacking the Traffic Assist
Highspeed
Checking the delivery
Before the Traffic Assist Highspeed is
started up, the delivery should be che-
cked to ensure that it is complete and in
the correct condition (see also page 12).
!Carefully unpack the content of the
package and check it.
Delivery contents
Note:
Your Traffic Assist Highspeed is sup-
plied in stable packaging. Do not un-
pack the unit in full if you discover any
serious damage to the packaging or its
content. If this happens, please contact
your local stockist.
4010

8
The Traffic Assist Highspeed
Complaints procedure
Please contact your local stockist if you
have any complaints. The unit can also
be sent directly to Harman/Becker in its
original packaging.
Handling the packaging
Keep the original packaging in a dry
place, at least for the warranty period.
Description of unit
The Traffic Assist Highspeed consists of
the basic unit Traffic Assist Highspeed
and the accessories included in the deli-
very.
You will find photos of the individual
parts under:
• "Overview Traffic Assist High-
speed" on page 12
Traffic Assist Highspeed - basic
unit
The basic unit comprises the entire elec-
tronics, an integrated antenna for GPS
signal reception, a touch screen for com-
munication, an integrated loudspeaker
for the output of messages during navi-
gation as well as for MP3 files, illumina-
ted strips along the sides of the unit and
various connections and interfaces.
You will find more details of the unit
under:
• "Technical Data" on page 83
Note:
The packaging should be disposed of
correctly in accordance with national
disposal guidelines. The packaging
must not be burnt. Depending on the
country to which the unit is supplied, it
may be possible for local stockists to
accept packaging.
Note:
The basic unit and accessories must not
be opened or modified in any way.

9
The Traffic Assist Highspeed
Cable for power supply from
cigarette lighter
This cable allows the unit to be connec-
ted up to the car's cigarette lighter.
The power supply must satisfy the follo-
wing requirements:
• DC current 12 volts
0.5 amps
Battery
When depleted, the integrated recharge-
able battery can be recharged by connec-
ting the Traffic Assist Highspeed to the
power supply.
For this purpose, connect the unit to a
computer via the USB connecting cable,
connect it to a 12 V socket in a vehicle
using the car power adapter, or charge it
using the optional mains power supply
unit connected the 230 V grid.
SD memory card
A memory card is used as a storage me-
dium for road maps, music tracks and
images.
The card supplied with the unit can hold
one set of roadmaps. If you intend to lis-
ten to music using the Traffic Assist
Highspeed or want to view images, you
must save these to a separate card (not
included).
When not in the unit, the memory card
must be stored in a protected dry place
away from direct sunlight in the pa-
ckaging supplied. Avoid touching or dir-
tying the contact strip.
You will find more details about the me-
mory card under:
• "Technical Data" on page 83
USB connection cable
The USB connection cable can be used
to connect the unit to a standard personal
computer by means of the USB port.
You can charge the Traffic Assist High-
speed using the USB cable. However, to
use the data on the PC, you will first
have to install the free "Active Sync"
software from Microsoft®.
Unit bracket
The Traffic Assist Highspeed can be
mounted in the vehicle using the unit
bracket.
Note:
Playback of music while an active navi-
gation is in progress is only possible if
a memory card with a higher storage ca-
pacity is used (available separately).
This can be used to store additional map
material as well as music tracks.