Operating Manual | EMS-58 | Beckmann GmbH
and the remaining seconds are displayed. After the time has run out completely the
display shows „0“ and the output shuts off.
4. Door opener (optional)
This feature is mainly provided for washing machines and dryers. As some washing
machines or dryers need power in order to open the door, the EMS 58 TE owns a push
button at the front, that can be used for switching the output for a moment. The duration
can be determined by parameter P12 within the programming area. During this time the
door of the device may be opened. This procedure may be repeated as often as
programmed at parameter P14. If the key was pressed too often, the door opener will be
blocked for a certain time. This time can be programmed with parameter P15. After the
blocking time has run out the output can be switched again as described before.
5 Programming
5.1 Procedure
For the programming of the EMS 58, the device has to be opened. At the control board
inside of the ISO box there are three buttons available.
CAUTION:
You absolutely have to pay attention that the EMS 58 is in ”free” state
(display must show 0) because otherwise an emergency stop occurs by
pressing the ”P” button The device immediately goes over into “free” state
By pressing the ”P” button you are in the programming mode. The display shows
alternating a ”P”, followed by the parameter number and the value of the respective
parameter. Press the ”P” button several times until you reach the required parameter.
You can find a listing of all parameters in Table 1, section 5.5. When you leave the last
parameter all settings are stored and the EMS 58 is in “free” state again. All parameters are
stored electronically and do not loose their values even if the device is switched off. If no
button is pressed for a period of at least 30 seconds, all settings are stored automatically
and the EMS 58 changes over to “free” state.
In the following sections the 3 types of parameters, counter, operating values and
switches, are described.
5. Counter editing
Counters are cash counters, customer counters or hour meters. There are erasable and
non-eraseable counters. The erasable counters can be erased by pressing the ”+” or ”-”
button. The counters have a range reaching from ”0” to ”99999.9”. As the display has only
3-digits, the notation is segmented on values higher than 1000. The display changes
between the parameter-number, the high level digits (digits 4 - 5) and the low level digits
(digits 1 - 3). The high level digits are indicated by the flashing decimal point at the right
side. In Figure 4 you can see an example for the counter operating hours 1 with a
counter value of 21 740 hours. If the value is lower than 1.000 the display changes only
between the parameter number and the low level digit display.
Figure 4: Counter display for larger values
Page 7
