Money Control SR3 User manual

SR3 Type 1 Technical Manual TSP005.doc Issue 5.0 – Jan 2005
This document is the copyright of Money Controls Ltd and may not be reproduced in part or in total by any means,
electronic or otherwise, without the written permission of Money Controls Ltd. Money Controls Ltd does not accept
liability for any errors or omissions contained within this document. Money Controls Ltd shall not incur any
penalties arising out of the adherence to, interpretation of, or reliance on, this standard. Money Controls Ltd will
provide full support for this product when used as described within this document. Use in applications not covered
or outside the scope of this document may not be supported. Money Controls Ltd. reserves the right to amend,
improve or change the product referred to within this document or the document itself at any time.
Money Controls 2005. All rights reserved.

SR3 Type 1 Technical Manual TSP005.doc Issue 5.0 – Jan 2005
Money Controls 2005. All rights reserved.
Page 2 of 50
Contents
1. Diary of Changes ........................................................................................................................................... 5
2. Introduction.................................................................................................................................................... 6
3. Mechanical Configuration............................................................................................................................. 7
4. Rear Cover Details....................................................................................................................................... 10
5. Parallel Interface.......................................................................................................................................... 11
5.1 Inhibit All ................................................................................................................................................ 11
5.2 Coin Accept Outputs.............................................................................................................................. 12
5.3 Reject .................................................................................................................................................... 12
6. Credit Codes ................................................................................................................................................ 13
6.1 Standard Parallel Credit Codes ............................................................................................................. 13
6.2 Standard Binary Credit Codes ............................................................................................................... 13
7. Debug Features ........................................................................................................................................... 14
8. DIL Switch Options...................................................................................................................................... 15
9. Accept and Inhibit Configuration ............................................................................................................... 16
9.1 To Inhibit Specific Coins ........................................................................................................................ 16
9.2 To Enable Specific Coins....................................................................................................................... 16
10. Bank Select .............................................................................................................................................. 17
10.1 Both Banks ON...................................................................................................................................... 17
10.2 Bank 1 ON Bank 2 OFF......................................................................................................................... 17
10.3 Bank 1 OFF Bank 2 ON......................................................................................................................... 17
11. Teach and Run™ Option......................................................................................................................... 18
11.1 Programming Steps ............................................................................................................................... 18
11.2 BANK 1.................................................................................................................................................. 19
11.3 BANK 2.................................................................................................................................................. 19
12. Erase All Windows .................................................................................................................................. 20
13. Adjustable Coin Security ........................................................................................................................ 21
13.1 Decrease Security ................................................................................................................................. 22
13.2 Increase Security................................................................................................................................... 22
13.3 Reset Security ....................................................................................................................................... 22
14. Alarms ...................................................................................................................................................... 23
14.1 Enable ................................................................................................................................................... 23
14.2 Disable................................................................................................................................................... 23
15. Diagnostics (power-up)........................................................................................................................... 24
16. Sorter Option ........................................................................................................................................... 24
16.1 Sorter Mode 1 (default).......................................................................................................................... 24
16.2 Sorter Mode 2........................................................................................................................................ 24
16.3 Sorter Mode 3........................................................................................................................................ 24
17. Sorter Drivers........................................................................................................................................... 25
17.1 Sorter Drive Circuit ................................................................................................................................ 25
17.11 Theory of operation........................................................................................................................ 25
17.2 Sorter Drive Examples........................................................................................................................... 26
17.3 Sort Outputs v Sorter Paths................................................................................................................... 26
18. Totaliser Mode ......................................................................................................................................... 27
18.1 19 way Parallel Interface Connector ...................................................................................................... 27
18.2 CMETER ............................................................................................................................................... 28
18.3 Player 1 HI / Player 1 LO ....................................................................................................................... 29
18.4 Player 2 to 4 .......................................................................................................................................... 29
18.5 Dispense 1 to 4...................................................................................................................................... 30
19. Totalising Options ................................................................................................................................... 31
19.1 Set a Game Price .................................................................................................................................. 31
19.2 Set Bonus Level 1.................................................................................................................................. 32
19.3 Set Bonus Level 2.................................................................................................................................. 32
19.4 Set Bonus Award Level 1 ...................................................................................................................... 33
19.5 Set Bonus Award Level 2 ...................................................................................................................... 33
19.6 Test Credit Mode ................................................................................................................................... 34
19.7 Summary of Totalising Functions........................................................................................................... 35
20. Totalising Parameters ............................................................................................................................. 36
21. Coin Dimensions ..................................................................................................................................... 37
22. Label Details Explained........................................................................................................................... 38

SR3 Type 1 Technical Manual TSP005.doc Issue 5.0 – Jan 2005
Money Controls 2005. All rights reserved.
Page 3 of 50
23. Protocols .................................................................................................................................................. 39
23.1 Serial Interface ...................................................................................................................................... 39
24. ccTalk Serial Messages.......................................................................................................................... 40
25. ccTalk Interface Circuits ......................................................................................................................... 42
25.1 Circuit 1 – ccTalk Standard Interface..................................................................................................... 42
25.2 Circuit 2 – ccTalk Low Cost Interface .................................................................................................... 43
25.3 Circuit 3 – ccTalk Direct Interface.......................................................................................................... 44
25.4 Circuit 4 – ccTalk PC Interface .............................................................................................................. 45
26. Fault Finding ............................................................................................................................................ 46
27. Service...................................................................................................................................................... 47
28. Electrical Interface Requirements.......................................................................................................... 47
29. Specified EMC Performance................................................................................................................... 48
29.1 Emissions .............................................................................................................................................. 48
29.2 Immunity ................................................................................................................................................ 48
29.3 Shock / Vibration Immunity .................................................................................................................... 48
30. Appendix A – Available Parallel Interface Looms................................................................................. 49
Tables
Table 1: SR3 Rear Cover Details. ......................................................................................................................... 10
Table 2: Parallel Interface...................................................................................................................................... 11
Table 3: Debug Features ....................................................................................................................................... 14
Table 4: DIL Switch Functions ............................................................................................................................... 15
Table 5: SR3 DIL Switch Guide ............................................................................................................................. 15
Table 6: Teach and Run™ Programming - Bank 1............................................................................................... 19
Table 7: Teach and Run™ Programming - Bank 2............................................................................................... 19
Table 8: DIL Switches - Decrease Security ........................................................................................................... 22
Table 9: DIL Switches - Increase Security............................................................................................................. 22
Table 10: Sort Outputs v Sorter Paths................................................................................................................... 26
Table 11: 19 way Parallel Interface Connector ...................................................................................................... 27
Table 12: SR3 Totalising DIL Switch Guide........................................................................................................... 31
Table 13: Totalising Parameters............................................................................................................................ 36
Table 14: ccTalk Serial Commands ..................................................................................................................... 40
Table 15: Error Codes ........................................................................................................................................... 41
Table 16: Fault Codes ........................................................................................................................................... 41
Table 17: Status Codes ......................................................................................................................................... 41
Table 18: Power Supply ........................................................................................................................................ 47
Table 19: Current Consumption............................................................................................................................. 47
Table 20: Environmental Ranges .......................................................................................................................... 47
Table 21: Available Parallel Interface Looms......................................................................................................... 49

SR3 Type 1 Technical Manual TSP005.doc Issue 5.0 – Jan 2005
Money Controls 2005. All rights reserved.
Page 4 of 50
Figures
Figure 1: Accept and Reject Paths .......................................................................................................................... 7
Figure 2: Front Plate Model Details ......................................................................................................................... 8
Figure 3: Front Plate Cut-out Details ....................................................................................................................... 8
Figure 4: Standard Model Details ............................................................................................................................ 9
Figure 5: Reverse Model Details ............................................................................................................................. 9
Figure 6: SR3 Connector Side............................................................................................................................... 10
Figure 7: SR3 Parallel Connector .......................................................................................................................... 11
Figure 8: Coin Accept Outputs............................................................................................................................... 12
Figure 9: Reject Operated Output.......................................................................................................................... 12
Figure 10: Sort Output Connector Details.............................................................................................................. 25
Figure 11: Sorter Drive Output Circuit ................................................................................................................... 25
Figure 12: Sorter Drive Examples.......................................................................................................................... 26
Figure 13: CMETER Output .................................................................................................................................. 28
Figure 14: Player 1 HI / Player 1 LO Output .......................................................................................................... 29
Figure 15: Player 2 to 4 Outputs............................................................................................................................ 29
Figure 16: Dispense 1 to 4 Inputs.......................................................................................................................... 30
Figure 17: SR3 Accepted Coin Dimensions Graph................................................................................................ 37
Figure 18: ccTalk Serial Connector....................................................................................................................... 39
Figure 19: Circuit 1, ccTalk Standard Interface..................................................................................................... 42
Figure 20: Circuit 2, ccTalk Low Cost Interface .................................................................................................... 43
Figure 21: Circuit 3, ccTalk Direct Interface.......................................................................................................... 44
Figure 22: Circuit 4, ccTalk PC Interface .............................................................................................................. 45

SR3 Type 1 Technical Manual TSP005.doc Issue 5.0 – Jan 2005
Money Controls 2005. All rights reserved.
Page 5 of 50
1. Diary of Changes
Issue 2.0................................................................................................................September 2000
Issue 3.0................................................................................................................ 29th March 2002
¾Title changed to SR3 Type 1
¾Added credit code details
¾Added label description
¾Output diagrams added
¾Totaliser option added
¾Fault finding table added
¾Sorter option added
¾ccTalk headers and circuits added
¾Power-up Diagnostics added
¾Re-ordered headings
¾Amended last page disclaimer
¾Table references on page 14 corrected
¾Table references on page 17 corrected
¾Section references on page 17 corrected
¾Table references on page 19 corrected
¾Erase all windows MechToolTM option added
¾Dimensional information added
¾Applied TMWP V3.0
¾Pictures changed to .jpg
¾Added section on available interface looms
Issue 4.0................................................................................................................... 26th April 2002
¾Added Figure 7: SR3 Parallel Connector
¾Added switch drawings for visual indication
Issue 4.1..................................................................................................................... 6th Sept 2002
¾Modification to disclaimer.
Issue 4.2.................................................................................................................... 18th Feb 2003
¾Typing error in section 5.3 Pin 6 changed to Pin 5
¾Applied TMWP V3.2
¾Changed the ‘high’ voltage of Inhibit All.
Issue 4.3...................................................................................................................... 6th Aug 2003
¾Changed ccTalk®to ccTalk throughout the document.
Issue 4.4...................................................................................................................30th June 2004
¾Changed footer
Issue 5.0.....................................................................................................................13th Jan 2005
¾Improved section 17 “Sorter Drivers”.
¾Changed links for Figure 1 to Figure 6.

SR3 Type 1 Technical Manual TSP005.doc Issue 5.0 – Jan 2005
Money Controls 2005. All rights reserved.
Page 6 of 50
2. Introduction
The SR3 series of coin acceptors has been designed to be compatible with the standard 3.5”
mechanical and electronic acceptors currently used throughout the vending, amusement and
leisure industries.
Through the development of Series Resonance Technology, the SR3 incorporates the highest
levels of discrimination and functionality. Each acceptor within the series will accept up to 12
different coins from 15mm – 31mm in diameter.
The SR3 can be programmed on site without the use of coins using “ccProgrammer”, or using
a ccTeach programmer but for total flexibility, if a new coin/token is required, the Teach and
Runfunction can be used.
The SR3 Type1 has the option to attach an external totaliser PCB and has the capability to
drive an external sorter.

SR3 Type 1 Technical Manual TSP005.doc Issue 5.0 – Jan 2005
Money Controls 2005. All rights reserved.
Page 7 of 50
3. Mechanical Configuration
Figure 1: Accept and Reject Paths

SR3 Type 1 Technical Manual TSP005.doc Issue 5.0 – Jan 2005
Money Controls 2005. All rights reserved.
Page 8 of 50
Figure 2: Front Plate Model Details
Figure 3: Front Plate Cut-out Details

SR3 Type 1 Technical Manual TSP005.doc Issue 5.0 – Jan 2005
Money Controls 2005. All rights reserved.
Page 9 of 50
Figure 4: Standard Model Details
Figure 5: Reverse Model Details

SR3 Type 1 Technical Manual TSP005.doc Issue 5.0 – Jan 2005
Money Controls 2005. All rights reserved.
Page 10 of 50
4. Rear Cover Details
Figure 6: SR3 Connector Side
Table 1: SR3 Rear Cover Details.
1 Option Switches
2LED
3 Serial Interface (ccTalk)
4 Sorter Connector
5 Totaliser Connector
6 Parallel Connector
7 Reject Lever