
5/EN
Electrical safety
•If the product has a failure,
it should not be operated
unless it is repaired by an
Authorised Service Agent.
There is the risk of electric
shock!
•Only connect the product
to a grounded outlet/line
with the voltage and pro-
tection as specified in the
“Technical specifications”.
Have the grounding instal-
lation made by a qualified
electrician while using the
product with or without a
transformer. Our company
shall not be liable for any
problems arising due to the
product not being earthed
in accordance with the lo-
cal regulations.
•Never wash the product by
spreading or pouring water
onto it! There is the risk of
electric shock!
•Never touch the plug with
wet hands! Never unplug
by pulling on the cable, al-
ways pull out by holding
the plug.
•The product must be dis-
connected during installa-
tion, maintenance, clean-
ing and repairing proce-
dures.
•If the power connection
cable for the product is
damaged, it must be re-
placed by the manufactur-
er, its service agent or sim-
ilarly qualified persons in
order to avoid a hazard.
•The appliance must be in-
stalled so that it can be
completely disconnected
from the mains supply. The
separation must be provid-
ed by a switch built into the
fixed electrical installation,
according to construction
regulations.
•Rear surface of the oven
gets hot when it is in use.
Make sure that the electri-
cal connection does not
contact the rear surface;
otherwise, connections can
get damaged.
•Do not trap the mains ca-
ble between the oven door
and frame and do not route
it over hot surfaces. Oth-
erwise, cable insulation
may melt and cause fire as
a result of short circuit.
•Any work on electrical
equipment and systems
should only be carried out
by authorised and qualified
persons.