Belham Living Sorrento ALH2078-1 User manual

1
For assistance with assembly, please contact customer service
1-888-880-4884
ITEM NAME:Belham Living Sorrento
Aluminum Swivel Deep Seat Lounge
Chair-Set of 2
SKU:ALH2078-1

2
Please read instructions carefully and thoroughly before assembling. Check parts against the parts list to make sure
you have all the parts needed for proper assembly. Familiarize yourself with the inventory of parts and the accompa-
nying illustrations to ensure safe and proper assembly.
Place the chair on a non-abrasive flat surface to prevent scratching.
PART DESCRIPTION PICTURE QTY
A CHAIR SEAT 1
B CHAIR BASE 1
C BOLT (5/16”X45MM) 4
D METAL PLATE 4
E FLAT WASHER 4
F LOCK WASHER 4
G NUT 4
H BOLT CAP 4
I WRENCH 1
WARNING!
PARTS LIST
 Chairs have a 250 lbs weight capacity.
 Hang cushion over chair frame to dry if it gets wet to prevent mold/mildew.

3
Remove all protective material carefully. Avoid cutting
the surface of the furniture while removing the packag-
ing material.
Remove the Bolt (C), Metal Plate (D), flat washers (E),
lock washers (F) and nuts (G) from the spring late for
chair seat (A).
Place the chair seat (A) on a non-abrasive flat surface.
Align the holes on the support bar on the underside of
the chair seat with the holes on the spring plates at-
tached to the t-rocker that is pre-attached to the chair
base (B). Make sure the arrow labels on the rocker
mechanism and chair support bar are facing the same
direction—towards the front of the chair. Insert bolts
(C) through the metal plates (D), support bar, spring
plate and the metal plates (D) as showed in the dia-
gram. Secure bolts with flat washers (E), lock washers
(F) and nuts (G). The support bar and spring plate
should be sandwiched in between the metal plates (D).
Warning: Improper assembly may result in serious
personal injury.
Once all the nuts and bolts are in place, securely
tighten all the bolts (C) and nuts (G), including the
ones at the front part on the rocker mechanism with
the wrench (I). Cover all bolts with bolts caps (H).
(FIGURE 1)
1
Test the swivel rocker gently. If the rocker does
not rock properly, double check the assembly proce-
dure, especially step 1.
REPEAT ABOVE STEPS TO ASSEMBLE THE
OTHER ROCKING CHAIR.
(FIGURE 2)
Your end chair is ready for enjoy now.
2
Figure 1
Support bar
E
F
G
H
C
D
Figure 2
A
Spring plate
B