Belnick MK-STRG008-GG User manual

ASSEMBLY INSTRUCTIONS
Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the components from the packaging and
set aside for assembly. Assemble on a soft surface to prevent scratching during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury. DO NOT use any sharp objects to open plastic wrapped
components as damage to product or componenets may result.
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
The tipping restraint is intended only as a safety measure, it is not a substitute for proper adult supervision.
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware (where included) to help prevent the unit
from tipping and causing accidental injury, instability, death or damage. The tipping restraint is intended only as a safety measure,
it is not a substitute for proper adult supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall
Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.
Phillips screwdriver required for assembly (Not Included).
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE.
CHOKING HAZARD - Small Parts.
Not For Children Under 3 Years.
WARNING:
!
30 min
WARNING:
!
Adult assembly required. This item
contains small parts that have sharp
points and edges in the unassembled
state. Adults must be extra careful to
securely tighten all screws, make
sure the toy is properly assembled,
and ensure there are no left-over
metal parts (eg. Allen key) within
reach of children.
Before You Begin: Phillips screwdriver (not included) required for assembly
!
Customer Service Email: [email protected] | Phone: [phone]
Wooden 5 section School Classroom Storage Cabinet
for Commercial or Home Use - Safe, Kid Friendly
Design - 30”H x 48”L (Natural)
Online Assembly Instruction: http://ftp.flashfurniture.com/AssemblyInstructions/MK-STRG008-GG.pdf
MK-STRG008-GG

HAVE A QUESTION / CONCERN ?
Quality products and first-class customer service are the cornerstone of long-lasting consumer relationships.
We strive toward excellence in all we do and want you to be completely satisfied with your purchase.
Our Warranty Statement
This warranty covers manufacturing defects associated with your new product. The product is warranted from the original purchase date
Please contact our exceptional Customer Experience Agents at the email address or phone number shown below
We look forward to serving you in a friendly, efficient manner to resolve any issues you may have.
to assist you with any product questions or issues before requesting a return.
and to the original purchaser for normal usage, according to the below-referenced specifications and limitations.
Normal usage means use in compliance with the restrictions and weight limits specified forthe product. In the absence of product-specific restrictions
and weight limits, normal usage means use for no more than forty hours per weekby persons weighing 250 lbs. or less.
Coverage terminates if the product is sold or otherwise transferred. Repairs made by parties other than Belnick also void this warranty.
This warranty will not cover: (1) labor, freight, or damage from misuse, abuse, negligence, alteration, assembly, installation, attachments, accident, vandalism,
acts of nature or any other event beyond the control of Belnick; (2) tearing, scratching, scuffing, or blemishing of leather or fabric; (3) cosmetic damage
that may result from normal usage; (4) damage attributable to use by persons exceeding specified weight limits or commercial use exceeding forty hours
per week; or (5) rust or other damage caused by exposure to moisture. The user assumes all risk of injuryr esulting from use of this product. Liability for
incidental or consequential damage is excluded. Some states do not allow the exclusion or limitation of incidental or consequential damages,
so the above limitation or exclusion may not apply to you.
• Non-moving metal parts are warranted for 5 years.
• Component parts including pneumatic cylinder, control mechanism, base and casters are warranted for 2 years.
• All other items are warranted for 1 year.
Customer Service Email: [email protected]
Customer Service Phone: [phone]

Tool Required
20200829
Hardware Included:
E x 1
Wall Security
Strap
12
345
67
12
4
5
6 x 2
78 x 2
3
A x 13 B x 16 C x 1
D x 1
9 x 2
Pre-installed Cam Lock
A x 6
3
6 x 2
A x 2
A x 2
3
58 x 2
A x 2
4
7
1
B x 8
9 x 2
A x 1
4
2
B x 8
Left Panel Right Panel
Bottom Panel
Top Panel
Middle Panel
Base support
Top Separator Middle Separator
M4x35 M5x39
Rear panel
5
M4x16
M4x36

CHOKING HAZARD - Small Parts.
Not For C hildren Unde r 3 Years.
WARNING:
!
30 min
WARNING:
!
Adult assembly required. This item
contains small parts that have sharp
points and edges in the unassembled
state. Adults must be extra careful to
securely tighten all screws, make
sure the toy is properly assembled,
and ensure there are no left-over
metal parts (eg. Allen key) within
reach of children.
! WARNING
Serious or fatal crushing injuries can occur
from furniture tip-over. To help prevent
tip-over:
Install tip-over restraint provided.
Place heaviest items in the lowest drawers.
Do not set TV or other heavy objects on top
of this product. Remove unless the product
is specifically designed to accommodate them.
Never allow children to climb or hang on
drawers, doors, or shelves.
Never open more than one drawer at a time.
Do not defeat or remove the drawer interlock
system.
Use of tip-over restraints may only reduce,
but not eliminate, the risk of tip-over.
This is a permanent label, Do not remove!
FINISHED
MAX 100LBS
MAX 100LBS
Step1:
ATTACHING STABILIZING
STRAP(against wall)
E
C
E x 1
C x 1
Step2:
E
D
D x 1