3.3 Setting the heating function
1. Turn the knob for the heating functions to
select a heating function.
2. Turn the control knob to select the
temperature.
The lamp turns on when the oven operates.
3. Turn the knob for the heating functions to
the off position to turn off the oven.
3.4 Setting the function:
This function increases humidity during
cooking.
1. Fill the cavity embossment with tap water.
The maximum capacity of the cavity
embossment is 250 ml.
Fill the cavity embossment with water
only when the oven is cold.
CAUTION!
Do not refill the cavity embossment
during cooking or when the oven is
hot.
2. Set the function: .
3. Turn the control knob to set temperature.
4. Preheat the empty oven for 10 minutes to
create humidity.
5. Put food in the oven.
Do not open the oven door during cooking.
6. Turn the knob for the heating functions to
the off position to turn off the oven.
7. Remove water from the cavity
embossment.
WARNING!
Make sure that the oven is cold
before you remove the remaining
water from the cavity embossment.
3.5 Clock functions table
Clock function Application
Time of day To set, change or check the time of day.
Duration To set the coking time.
End To set the time when the heating function completes.
Time Delay To automatically turn the oven on or off at a given time. Set up Duration
and End at the same time.
Minute Minder To set a countdown timer. This function does not effect the operation of
the oven. You can set the Minute Minder at any time, also when the
oven is turned off.
3.6 Setting the clock functions
1. Press the again and again until the
display shows desired option.
2. Press or to set the time.
3.7 Cancelling the clock
functions
1. Press the again and again until the
necessary function indicator starts to
flash.
2. Press and hold .
The clock function goes out after some
seconds.
4 ENGLISH
