Bilkur Z-3191BT Instruction Manual

Wireless Handheld Gun Type Scanner
Mac OS X Quick Connection Guide
Version 1.00
ASCII Code 39 Table
0 1 2 3
4 5 6 7
8 9
A B C D
E F G H
I J K L
M N O P
Q R S T
U V W X
Y Z

Please follow the below instructions carefully to pair the scanner with
your Mac computer.
Step. 1
Press and hold the trigger for 2 seconds to power on the scanner.
Step. 2
On your Mac computer, select "About This Mac" then "More info".
Step. 3
Select "Bluetooth" to view the Bluetooth address.
Connect to Mac OS X via SPP Master Mode
Connecting to Mac
Step. 4
Enable the serial program you use for scanning (such as ZTerm).
Step. 5
Enable Scanner SPP Master mode by scanning the following barcodes.
Start of Conguration
SPP Master Enable
Step. 6
Scan “Set wireless address” to set the Bluetooth address.
Set wireless address
Step. 7
Use the ASCII table to scan the 12 digit Bluetooth address you found in
Step 3. For example: if the address is “011B1345600”, scan “0”, “0”, “1”,
“1”, “B”, “1”, “3”, “4”, “5”, “6”, “0”, “0” from ASCII barcode labels.
Step. 8
Scan “Conrm Setting” to store the address then scan "Pairing" to pair
the scanner to the computer. (or you can print out a barcode containing
the full address and scan it)
Conrm Setting
Pairing
Step 9
Quickly enter the PIN code on the computer. The default PIN code is
"12345678". The scnner is now paired to the Mac.
Step 10
Enable the COM port using the serial program started in Step.4 to
begin scanning.
Press and hold trigger