Bio-Therapeutic bt-analyze User manual
bt-analyze®quick start guide
3. Turn on the bt-analyze by
holding the power button
(A) for 2-3 seconds.
Proceed by pressing
the memory button (B).
The unit will calibrate itself.
Skin Care for life inside and out®
4. Place the bt-analyze on the
surface of the skin. A beep
will signify the reading is
complete. During the
reading, do NOT press
the power or memory
buttons.
5. Press the memory button to save
the reading at the top of the
display screen. Readings will
save in the order you perform
them.
1. Read operation manual prior to using the equipment.
2. Do not use the unit if any contraindications are present.
B
A
By the numbers:
Range: 0 - 65
Dry: 25 or below
Optimum: 35 - 45
High level of hydration: 55+
SA-58 REV071918
6. Follow steps 4 and 5 on the 7 zones of the face.
1
32
7
6
54
Reminder:
A soiled sensor slows calibration and reading times. Wipe
the sensor without pressing down with a clean, dry tissue
between each reading and with an alcohol wipe after each
use. Always remember to replace the cover when not in use.
The bt-analyze sensor will make a slight click when
depressed during moisture readings; this is normal. A
reading of “UUU” means an error has occurred.
Wipe down your bt-analyze with Opticide-3 wipes after
each use.
bio-therapeutic.com
