Bison PK05XL User manual

1
P A R T S L I S T
Item Qty Description Item Qty Description
A 1 Winch Post E 1 TN10CS Center Strap
B 1 Non-Winch Post F 1 TNCSA Center Strap Anchor
C 2 Lacing Cord G 2 PK230 or PK235 Socket (Optional)
D 1 PK10NXL Pickleball Net
 Inspect all contents prior to installation. Report any missing parts to dealer immediately.
 Read all instructions before proceeding.
—— Instruction Manual ——
PK05XL
Recreational Pickleball System
Date: 11/8/2018 Rev: 1 B.A. N.J.C. File: \pub\tn05 Ref#: 960925
3. Dig one 8" round and a minimum 12" deep hole centered between the
two pickleball posts (make sure to bell out the bottom of the hole). Insert
TNCSA Center Strap Anchor (F) with the strap retaining bar running
parallel with the PK10NXL Net (D) and fill hole with concrete. The hole
will require 2 to 3 1/3 cubic bags of concrete. See Figure 2.
4. Concrete must cure 7-10 days before continuing with PK10NXL Pickleball
Net (D) installation.
5. Stretch out PK10NXL Pickleball Net (D) across the court.
Note:
Use models PK23 or PK235 Sockets (G) for removable post installation. Use
instructions provided with these sockets for installation procedure.
6. Hook the loop on the PK10NXL Pickleball Net (D) top cable on the net
retaining hook on Non-Winch Post (B) and over the top cable guide.
See Figure 3.
7. Cut off loop and remove 12” of nylon cable coating from the top net
cable, insert cable into the winch cable hole on the Winch Post (A).
Crank cable until you achieve 34” at the center of PK10NXL Pickleball
Net (D). See Figure 4.
FIGURE 1
1. Use the attached court diagram to determine where to locate and dig two 8” round and 48” deep holes 22
feet apart. See Figure 1.
2. Insert Winch (A) and Non-Winch (B) posts into the holes with the lacing ties facing the pickleball court
and fill holes with concrete. Each hole will require between 6 and 8 1/3 cubic foot bag of concrete. Make
sure to brace post while concrete is curing to maintain the 36 1/2” dimension and ensure the posts
remain perpendicular to the court surface. See Figure 1.

2
FIGURE 2
8. Insert dowels through the end side tapes of PK10NXL Pickleball
Net (D).
9. Square up PK10NXL Pickleball Net (D) to each post, use Lacing
Cord (C) to secure PK10NXL Pickleball Net (D) to each post.
See Figure 3.
10. Attach TN10CS Center Strap (E) to the strap retaining bar in the
TNCSA Center Strap Anchor (F). Adjust TN10CS Center Strap (E)
so top of PK10NXL Pickleball Net (D) measures 34” at the center.
See Figure 2.
WINCH CABLE HOLE
WINCH POST (A)
FIGURE 4
FIGURE 3