Blitz Audio BZCAPT20 User manual
1
MODEL: BZCAPT20
2 FARAD POWERFUL TRIANGLE CAPACITOR.
Capacitance------------------------------------ 2,000,000 micro farad (2 farad)
Working Voltage------------------------------ 21 DC
Surge Voltage---------------------------------- 24 DC
E.S.R. (Equivalent Series Resistance)------ 0.0015 ohm @120hz/ 25°C
Capacitance Tolerance------------------------ ± 10%
You must first attach the mounting tabs to the Stiffening Capacitor before
mounting it. Use the supplied hardware shown in the picture to the right.
Notice the small mounting screw hole in the capacitor chassis.
Detail function:
a) 4-digit hi-end red light display DC voltage meter that can measure 0.01
DCV range. And PCB working status Flash blue LEDS (4pcs).
b) Electronic Polarity Protection Circuit. If the capacitor is connected
incorrectly by reversing the positive and negative wires during the
installation process, the PCB will issue a 45 seconds noise to warn you.
c) Over-voltage Protection Circuit. When the install system voltage over
17.5 DCV or LESS 10 DCV limit, the buzz on the PCB will issue an
audible noise warning.
d) Lowest E. S. R. 24 DCV foil with maximum moment discharge power
in lowest E. S. R..
2
The capacitor must be charged before connecting the Power and Ground
cables to the capacitor. Failure to charge the capacitor will result in a
large spark generated from the rapid inflow of current.
B ATTE R Y
+)(
-- )(
C H AR G IN G
B U LB
To Charge the capacitor:
1. Make Capacitor positive terminal connections with amplifier and
tighten the bolt. Do not over-tighten the bolts!
Caution: Stripped terminals are not covered under the capacitor’s
warranty.
3
2. Connect the ground cable with battery, amplifier, then refer to the
attached drawing.
3. Place the supplied charging bulb or resistor between the positive
terminal of the capacitor and the battery’s positive terminal. Do this
for 30 seconds or until the charging bulb goes out.
Caution: The charging bulb will get hot!
4. Immediately after the charging process, take out the charging bulb
from the connecting wire. And connect the positive cable of the
battery directly to the positive terminal on the capacitor.
5 Follow attached wiring drawing to connect all wire and parts.
Below is an illustration showing correct wiring for the capacitor.
Multiple Capacitor Wiring Diagram
Use a separate ground for the Capacitor as shown in the figure.
Do not connect the capacitor to the same ground that is used for the amplifiers.
WHEN YOU WANT TO MOVE THE CAPACITOR FROM
ORIGINAL INSTALLED CAR AUDIO SYSTEM. YOU MUST FIRST
PROCESS DISCHARGING PROCESS AFTER TAKE OUT THE
CAPOACITOR FROM THE CAR AUDIO SYSTEM.
4
BU LB
D IS C H AR G IN G
To Discharge the capacitor: With battery power disconnected, place the
light bulb or resistor across the capacitor’s positive and negative terminals
until light goes out or for three minutes if using a resistor.
One Year Warranty from the date of purchase.
