BluDot 2D 3D Coat Rack Quick start guide

2D:3D Coat Rack
DESIGNED IN 2006
ASSEMBLY NOTES | REV 00
NEED A HAND?
Contact us at [email protected] or
844.425.8368 for assistance.
@BLUDOT
We design all our pieces in our Minneapolis studio. Follow
along on Instagram for some sneak peeks into the process.

1 | 844.425.8368 2D:3D COAT RACK
Coat Rack
1QTY
Pt. 8054Pt. 1402
33 QTYQTY
Parts & Hardware

[e-mail] |2ASSEMBLY NOTES
Side View
Side View
Step 01
BEND FLAP UP.
Ensure that the coat rack is oriented in the
right orientation with the logo location shown.
Carefully bend the flap up as shown.
Step 02
INSERT TAB.
Bend the flap up and carefully push the tab
through the slot as shown.

3 | 844.425.8368 2D:3D COAT RACK
Side View
Step 04
FOLD REMAINING HOOKS.
Repeat steps 1-3 on the remaining hooks.
Step 03
SECURE TAB.
Bend the tab up as shown to secure the hook
in place.

[e-mail] |4ASSEMBLY NOTES
Side View
Side View
Step 06
BEND BASE UP.
Bend along remaining dotted line to make a 90
degree angle as shown.
Step 05
BEND BASE BACK.
Bend along lower dotted line to make a 90
degree angle as shown.

5 | 844.425.8368 2D:3D COAT RACK
Step 08
MARK WALL LOCATIONS.
Position the coat rack on the wall in your
desired location. Ensure that the coat rack is
level by using a leveling device before marking
the hole locations with a pencil.
Step 07
COMPLETE ASSEMBLY.
Bend the top flange forward slightly so it
is flush with the back panel to complete
assembly.

[e-mail] |6ASSEMBLY NOTES
PT. 8054 x 3* PT. 1402 x 3
Step 09
ATTACH COAT RACK TO WALL.
Wall anchors and fasteners are included for
installation into drywall. Please consult your
local hardware professional to determine the
hardware best suited for your wall type.
If the mounting locations are not positioned on
a stud, drill 1/4” holes in the marked locations
and Insert wall anchor.
If the mounting locations are positioned on a
stud, this step of installing wall anchors may
be skipped. Instead, drill 1/8” pilot holes in the
marked locations.
Position coat rack in place with mounting
locations aligned. Install fasteners as shown.

BLU DOT DESIGN & MANUFACTURING, INC. DESIGNED IN MINNEAPOLIS, MN
Additional Information
CLEAN
Clean with a slightly damp, soft cloth. To remove dirt and fingerprints, use a quality cleaner formulated for
metal furniture. Wipe completely dry with a soft cloth.