BOERPLAY PSTE000.013 User manual

PSTE000.013
Toddler swing

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
TOE PST 000 013
Peuterschommel
Bandzitje
25-2-2011
BOER
SPEELTOESTELLEN
Afmetingen Dimensions
1,63m
1,41m
>0,35m
1,55 m
1,68 m
0,20m

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
TOE PST 000 013
Peuterschommel
Bandzitje
25-2-2011
BOER
SPEELTOESTELLEN
Obstakelvrije zone Obstacle free zone
Obstakelvrij WAS
Obstacle free WAS
Opvangzone
Impact area
Obstakelvrij EN-1176
Obstacle free EN-1176
1,75 m
2,72 m
5,40m 1,00m 6,40m
4,68 m

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
TOE PST 000 013
Peuterschommel
Bandzitje
25-2-2011
BOER
SPEELTOESTELLEN
Bodemplan Groundplan
0,60 m
3,20m
3,20m
1,56 m 1,50 m 1,62 m
0,35 m
0,71m
rondmarkering
Ground le el marker

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
TOE PST 000 013
Peuterschommel
Bandzitje
25-2-2011
BOER
SPEELTOESTELLEN
Modules Modules
Opmerking
BenamingRev.Bew.
Volgnr
Progr.Type#
Nr
Adventure playSchommelpaal
B003001PSTOD21
Adventure PlayBandenzitje
102001PSTOD
1
2
12
Geleverde modules:
Zie tabel
Montageinstructie:
- De hoo dmaten geven de maten van de staanders en vloeren aan
- De detailtekeningen geven speci iek de maten van de verbindingen aan
- De modules met buizen zijn op de tekeningen bemaat op bovenkant kopplaat
- Overige modules zijn bemaat op de bovenkant (klimwanden, paalkappen, etc.)
Montagevolgorde:
1 - Graa de gaten volgens het bodemplan
2 - Plaats 1(2x)
3 - Plaats 2, verbind deze aan 1(2x)
4 - Controleer o het toestel voldoet aan de a metingen zoals op blad 'a metingen'
5 - Dicht de gaten en verdicht het zand
Controles:
1 - Correcte opbouw en alle bevestigingsmiddelen
2 - Controleer de a metingen van de valbodem t.o.v. het toestel
Supplied modules:
See table
Assembly instruction:
- The main dimensions indicate the dimensions o the posts and loors
- The detailed dimensions show the speci ic dimensions o the connections
- The modules which contain tubes are dimensioned at the top o the langes
- Other modules are dimensioned at the top (climbing walls, caps or the posts, etc.)
Assembly sequence:
1 - Dig the holes according to the ground plan
2 - Place 1(2x)
3 - Place 2, attach it to 1(2x)
4 - Check that the equipment con orms to the dimensions shown on sheet 'dimensions'
5 - Close the holes and compact the sand
Checks:
1 - Correct assembly and all the asteners
2 - Check the dimensions o the sa ety area with regard to the play equipment
Typeplaatje
Identification plate
B

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
TOE PST 000 013
Peuterschommel
Bandzitje
25-2-2011
BOER
SPEELTOESTELLEN
Afmetingen Dimensions
0,00 m
1,36 m
1,46 m
1,71 m
0,00 m
1,49 m
1,71 m

LOGBOOK
(Onderstaand logboek kan gebruikt worden om te voldoen aan de eisen, gesteld in artikel 14 van het Warenwetbesluit Attractie- en Speeltoestellen)
Type indication Adventure Play
Product code PSTE000.013
Name of equipment Peuterschommel met bandzitje
Maximum height of fall 1,0 m
Year of construction 2017
Certificate 032432
inspection authority TUV Nederland QA BV
De Waal 21c, Best - 5684 PH Best
Name manufacturer BOERplay
Hyacintstraat 2 - 4255 HX Nieuwendijk
Phone: [phone]
Fax: [phone]
name installer
Description of equipment Toddler swing
Location of equipment
Data about the owner of the play equipment
Name:
Address:
Postcode and town:
Contact person:
Telephone number:
Data about the administrator of the play equipment
Name:
Address:
Postcode and town:
Contact person:
Telephone number:
PSTE000.013
Toddler swing

LOGBOOK
Inspection and maintenance intervals
Nr.
Inspection Maintenance
months
between
inspections
1
Verify equipment's stability, junctions and missing parts.
Inspect bolts, screws and nuts for absence, jams, corrosion
and wear.
Add missing parts, secure joints, apply missing fixing
agent and replace corroded parts.
1
2
Chec suspension for wear. Replace worn parts and/or remove non-functioning
parts.
1
3
Inspect rotating parts such as hinges, rolling-element
bearings, etc. for wear and acceptability.
Replace worn parts and/or remove non-functioning
parts.
1
4
Chec wood for splinters, unacceptable damage and signs of
rot. Especially at ground level.
Repair damage. Replace affected wood. Smoothen
splintered wood and sharp edges.
1
5
Inspect foundation for stability, tearing and coverage. Restore foundation and covering material.
3
6
Examine rubber and synthetic parts for wear, damage and
brea . Replace original parts.
3
7
Inspect metal for corrosion and damage in the coating. Restore any damaged coating (after removing rust and
applying primer).
6
Chec ropes, cables, chains and nets for wear and damage.
Steel cables and nets which are tensioned must be chec ed
for tension.
Replace parts where necessary. Steel cables and nets
must be tensioned.
3
9
Inspect equipment for unsafe changes and additions. Remove unsafe additions and correct unsafe changes.
1
10
Inspect safety surfaces. Restore and repair where necessary.
1
Remarks
1. If used intensively, all points require extra attention.
2. Extreme weather conditions and locations may require a higher inspection frequency. Discuss this with
the supplier.
3. Vandalism-sensitive locations require stricter inspections, possibly daily.
4. Check the terrain regularly for items that do not belong there, are unsafe or may be used wrongly.
Examples are poisonous plants, glass shards, etc. Frequency depends on strain.
5. Remember that bad maintenance leads to unsafe conditions and notably faster impoverishment of the
playground area.
6. Replacement parts can be ordered at the manufacturer with the part numbers on the module drawing.
Drawings can be found in de user guide.
7. The impact area shall be provided with impact attenuating surface according to the specified falling
height.
. This list is conform the CEN-standard "playground equipment and surfacing NEN-EN 1176-7".

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
MOD PST 001 003 B
Schommelpaal
Adventure play
29-9-2016
BOER
SPEELTOESTELLEN
Samenstelling module Assembly module
Opmerking
BenamingRev.Bew.
Volgnr
Progr.Type#Nr
BORG RVS M10DO MOER 020010011BSR2
1
M10 x 150 - RVS A2-70
Zeskantbout
150010021BSR22
ø10 X 60 - RVS A2-70
Houtdraadbout
060010022BSR43
M10 x 16 - RVS A2-70
Bolkopbout ISO 7380
016010023BSR14
M10SLUITRING 002010030BSR45
Donut zwart
Beschermdop M10-M12 060010DONKST26
6 MM ROODO VULDO JE 030006DOKST1
7
Dop zwart
Beschermdop M10-M12
060010DOKST28
M10 x 2.5 MMRING NYLON 000010RORKST19
Igus
Glijlager
048025IGSLAG210
Lengte =2300
aal 14-16
023160STOHO
111
UkkepukEindplaat schommelas
320561
UK
OME112
UkkepukSchommelas
B
320558
UK
SME
1
13
UkkepukLoopdeel scharnier
B
320559
UK
SME
114
Extra zwaar
Grondanker
372616
VRB
SME115
4
9
12
10
14
10
13
7
11
15
3
1 5
0,60m
Grondmarkering
Ground level marker
2
6
5
8

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
MOD PST 001 102 A
Bandenzitje
Adventure Play
30-9-2016
BOER
SPEELTOESTELLEN
Samenstelling module Assembly module
Opmerking
BenamingRev.Bew.
Volgnr
Progr.Type#Nr.
UkkepukScho elzitje
B
001001
UKP
SMD11
1
1
1
1