Bold MFG & Supply Gibson User manual

Gibson Mailbox Installation
HAND MADE
BY TRUE
CRAFTSMEN
www.boldmfg.com
[email protected]
877-BOLD MFG
Installation must be performed by qualified personnel.
Measuring tape
Continued
Instructions:
Included are
Electric Drill
(hammer drill and 3/8”masonry bit
required for solid masonry walls)
Tools & Supplies:
Level
Phillips
screwdriver
(2) plastic anchors
(2) screws
Measure the distance between the hardware holes located at the back of your mailbox. From
the the center of each hardware hole should be 12” inches apart.
Measure and mark the same distance on your wall. Ensure that the markings are level,
so that your mailbox will hang accordingly.
With the appropriate tool for your exterior covering, drill through your two marked holes.
If needed, install the plastic anchors
Install screws. Be sure to leave a ¾” gap from the wall.
Hang your mailbox and tighten the screws to secure it.
(for composite siding, drywall, and masonry walls. Not necessary on wood)

www.boldmfg.com
[email protected]
877-BOLD MFG
Installation must be performed by qualified personnel.
3/4”
12”