Gazebo penguin 436586 User manual

0
ZGP-331.436586 Grill Gazebo.0817-18.GP.EN.SUN SUN-HI
436586 GRILL GAZEBO
INSTALLATION MANUAL
DO NOT DESTROY THE BOXES UNTIL COMPLETELY ASSEMBLED
PLEASE VERIFY THE CONTENT OF EACH BOX AGAINST THE LIST OF PARTS
Two or more adults required for assembly
Base Dimensions 6’10 ½” x 4’11 ¼”; Largest Dimensions 7’10” x 4’11 ¼”

1
ZGP-331.436586 Grill Gazebo.0817-18.GP.EN.SUN SUN-HI
Before Assembly:
- Please don't destroy boxes until completely assembled.
- Please verify the content of each box against the list of parts.
- Read instructions and check that all parts are present in the boxes.
If any parts are missing, refer to warranty information on pg. 10.
- Assembly will require at least two persons and 2 hours.
- A stepladder will be required for assembly.
- The gazebo should be assembled on a level, flat surface.
Step 1:
Assemble each leg (A, B, C, D) onto base (E) using bolt (U), washer
(U-2), and acorn nut (U-1). Each base can be installed in 4
directions, orient as required for your surface.
Step 2:
Assemble shelf support bar (F-1) under each top
shelf (F) using 4 bolts (Bb) and locknuts (Aa-1)
each. Attach one shelf between legs (A & C)
using 4 bolts (X). Repeat with the second top
shelf between legs (B & D).

2
ZGP-331.436586 Grill Gazebo.0817-18.GP.EN.SUN SUN-HI
Step 3:
Attach the rear bars (G) between legs (A & B) using 2 bolts (Z) at each end. Then install the central
bar (G-1) at the center of the two rear bars, using bolts (W).

3
ZGP-331.436586 Grill Gazebo.0817-18.GP.EN.SUN SUN-HI
Step 4:
Attach the bottom side bars (H) at the bottom between legs (A & C) and (B & D) using bolts (U).
Attach the top side bars (I) at the top between legs (A & C) and (B & D) using bolts (Z). Attach the top
bars (J) between legs (A & B) and (C & D), again using bolts (Z).

4
ZGP-331.436586 Grill Gazebo.0817-18.GP.EN.SUN SUN-HI
Step 5:
Screw shelf brackets (K-1) to the bottom of the shelf (K) on each side, using bolt (Aa) and locknut
(Aa-1). Then attach the shelves and shelf brackets between the left legs (A & C) using bolts (Z).
Screw cloth holder brackets (L-1 & L-2) to the cloth holder (L) using bolts (Z). Then attach them
between the right legs (B & D), also using bolts (Z).
Step 6:
For the upper roof, lay out edge rafters (M & M-1), two edgings (O), roof panels (P), and rafters (Q),
as shown in diagram. Attach rafter (M-1) and one edging (O) in one corner using a roof connector (R)
and 4 bolts (Cc). Do the same with rafter (M) and the other edging (O) at the opposite corner.

5
ZGP-331.436586 Grill Gazebo.0817-18.GP.EN.SUN SUN-HI
Step 7:
Bend and slide roof panel (P) into one corner, then insert rafter (Q) next to it,
attaching the ends to the edging (O) with bolts (Cc). Add the next roof panel
(P), then another rafter (Q) in the same manner. Insert the final roof panel (P),
and then close the upper roof with the previously assembled corner (M & O),
using roof connectors (R) at the corners and bolts (Cc).
Step 8:
For the lower roof, lay out edge rafters (N & N-1), two edgings (O), roof panels (P-1), and rafters (Q-
1), as shown in diagram. Then repeat steps 6 and 7 using these pieces to complete the lower roof.

6
ZGP-331.436586 Grill Gazebo.0817-18.GP.EN.SUN SUN-HI
Step 9:
Attach roof supports (S) to the center of each top bar (J) using one bolt (V) each.
Attach the lower roof assembly to the roof supports (S) using bolts (W), and to the top of legs (B & D)
using 2 bolts (Y) per leg.
Attach the upper roof assembly to the plate on lower rafters (N & N-1) using bolts (Z), and to the top
of legs (A & C) using 2 bolts (Y) per leg.
Step 10:
Anchor the unit to the ground through the bases (E). Use the provided nails (Dd), screws, and/or
plugs as appropriate for your surface. If using nails, be sure to drive them in at an angle. Hang rack
(T) and hooks (T-1) from the top side bar (I) as preferred.
I

7
ZGP-331.436586 Grill Gazebo.0817-18.GP.EN.SUN SUN-HI
DESCRIPTION
PACKED
IN BOX
QTY
DRAWING
DESCRIPTION
PACKED
IN BOX
QTY
DRAWING
(12-051)
BACK LEFT
LEG
A
1
1
(14-064)
TOP BAR
J
1
2
(12-052)
BACK
RIGHT LEG
B
1
1
(12-063)
LOWER
SHELF
K
3
2
(12-053)
FRONT
LEFT LEG
C
1
1
(12-064)
SHELF
BRACKET
K-1
1
4
(12-054)
FRONT
RIGHT LEG
D
1
1
(12-065)
CLOTH
HOLDER
L
1
1
(12-055)
BASE
E
1
4
(12-066)
CLOTH
HOLDER
BRACKET
L-1
1
1
(12-056)
TOP SHELF
F
3
2
(12-067)
CLOTH
HOLDER
BRACKET
L-2
1
1
(12-057)
SHELF
SUPPORT
BAR
F-1
1
2
(12-068)
UPPER
EDGE
RAFTER
M
1
1
(12-058)
REAR BAR
G
1
2
(12-069)
UPPER
EDGE
RAFTER
M-1
1
1
(12-059)
CENTRAL
BAR
G-1
1
1
(12-070)
LOWER
EDGE
RAFTER
N
1
1
(12-060)
BOTTOM
SIDE BAR
H
1
2
(12-071)
LOWER
EDGE
RAFTER
N-1
1
1

8
ZGP-331.436586 Grill Gazebo.0817-18.GP.EN.SUN SUN-HI
DESCRIPTION
PACKED
IN BOX
QTY
DRAWING
DESCRIPTION
PACKED
IN BOX
QTY
DRAWING
(12-061)
TOP SIDE
BAR
I
1
2
(12-072)
EDGING
O
1
4
(12-073) 54
¾” x 19”
UPPER
ROOF
PANEL
P
2
3
(12-081)
BOLT
V
1
4
M6x50mm
(12-074) 48” x
19”
LOWER
ROOF
PANEL
P-1
2
3
(12-082)
BOLT
W
1
2
M6x40mm
(12-075)
UPPER
RAFTER
Q
1
2
(12-083)
BOLT
X
1
8
M6x35mm
(12-076)
LOWER
RAFTER
Q-1
1
2
(12-084)
BOLT
Y
1
8
M6x30mm
(12-077)
ROOF
CONNECTO
R
R
1
8
(12-085)
BOLT
Z
1
40
M6x20mm
(12-078)
ROOF
SUPPORT
BAR
S
1
2
(08-158)
BOLT
Aa
1
4
M6x16mm
(12-079)
RACK
T
1
1
(12-086)
LOCKNUT
Aa-1
1
12
(12-080)
HOOK
T-1
1
4
(08-168)
BOLT
Bb
1
8
M6x12mm

9
ZGP-331.436586 Grill Gazebo.0817-18.GP.EN.SUN SUN-HI
DESCRIPTION
PACKED
IN BOX
QTY
DRAWING
DESCRIPTION
PACKED
IN BOX
QTY
DRAWING
(08-161)
BOLT
U
1
8
M6x70mm
(12-087)
BOLT
Cc
1
40
M5x8mm
(12-089)
ACORN
NUT
U-1
1
4
(08-181)
ALLEN KEY
1
1
(08-187)
WASHER
U-2
1
4
(12-088)
NAIL
Dd
1
4

10
ZGP-331.436586 Grill Gazebo.0817-18.GP.EN.SUN SUN-HI
MAINTENANCE NOTES
1. In case of a defective or damaged part, or for any other questions concerning the product, please
contact the manufacturer directly.
2. Please have the parts list and part numbers on hand when ordering or requesting replacement parts.
3. The product should not be installed adjacent to trees or a sloped roof. Snow and ice may slide onto the
roof and cause it to collapse.
4. While the product is designed for 4 seasons use, the roof must be kept free of accumulation of snow.
ONE YEAR LIMITED WARRANTY
This product has been designed and manufactured to meet the highest standards of quality and durability.
Subject to the Conditions for Exercising the Warranty and the Limitations on the Warranty set forth below, it is
warranted to be free of material and manufacturing defects for a period of one year from the date of purchase.
Should the product become damaged, or the warranty period has expired, please contact Gazebo Penguin
Customer Service Department for a complete schedule of replacement parts and prices.
CONDITIONS FOR EXERCISING THE WARRANTY
The warranty only applies to the original purchaser with the bill.
In order to properly exercise your warranty, please comply with the following:
Carefully inspect the contents of the carton for missing or damaged components. Should you discover
damaged or missing parts, do not return the product to the place of purchase, but contact Gazebo
Penguin Customer Service Department at the numbers listed below:
Montreal: [phone]
Elsewhere: 1-800-737-7174
You can also find a claim form to fill out online :
http://www.abrispenguin.com/forms.html
LIMITATIONS ON THE WARRANTY
1. The product is not warranted against damages due to vandalism, abuse, falling or thrown objects, or
accumulation of snow.
2. The product is not warranted against damages due to extreme weather conditions, such as
thunderstorms, hail, strong wind or snow storms, or any other acts of God.
3. The product is only warranted in the event it is installed in accordance with the Gazebo Penguin’s
written instructions enclosed with the product.
4. The product is not warranted in the event it has been improperly anchored.
5. We reserve the right to replace or repair any defective product or parts at our discretion.