BONTEC ST-12 User manual

Model: ST-12
      
INSTALLATION MANUAL

Supplied Parts
1

Carefully open the carton, remove contents and lay out on cardboard or other
protective surface to avoid damage.
Check package contents against the Supplied Parts List in the next page to
assure that all components were received undamaged. Do not use damaged
or defective parts.
Carefully read all instructions before attempting installation.
  
Install and operate this device with care. Please read this instruction before
beginning the installation, and carefully follow all instructions contained herein.
Use proper safety equipment during installation.
Please call a qualified installation contractor for help if you:
If you don't understand these directions or have any doubts about the safety of
the installation.
If you are uncertain about the nature of your wall, consult a qualified installation
contractor.
Do not use this product for any purpose or in any configuration not explicitly
specified in this instruction.We hereby disclaim any and all liability for injury
or damage arising from incorrect assembly, incorrect mounting, or incorrect
use of this product.
Tempered Glass Support Pillar TV Plate
Monitor Bracket Plastic Cover Rotating Parts
M-A (X4)
M4x30 Bolt
M-B (X4)
M6x15 Bolt
M-C (X4)
M6x30 Bolt
M-D (X4)
M8x20 Bolt
M-E (X4)
M8x50 Bolt
M-F (X8)
5mm Spacer
M-G (X8)
10mm Spacer
M-H (X4)
Square Washer
1 (X1) 2 (X1) 3 (X1)
4(X2) 5 (X1) 6 (X1)

2
A (X4)
Rubber Foot
B (X2)
M6x20 Bolt
C (X3)
M6x16 Bolt D6 Metal Washer
D (X7)
D6 Plastic gasket
E (X3)
F (X4)
M6x40 Bolt
G (X4)
M6
H (X2)
Wire Clip Safety Lock
I (X2) J-1 (X1)
4mm Allen Key
J-2 (X1)
   
  
 
Back side 1A


Concentric holes
J-1
B
6
2
Back side
!!
Please pay attention to distingui-
shing the frontwards and the
backwards of the support pillar
and the places of the concentric
holes where the arrows point.
2
Wire clip hole

3
!!
C
D
E


Insert the part along the direction of the arrow (make sure the
direction of the arrow is perpendicular to the tempered glass )
to find the positions of the corresponding screw holes.
1
6
90°
✓
✕
Back side
correct
incorrect
The support pillar needs to
be maintained at a 45°
angle with the edge of the
glass for the screw holes to
be aligned
!!

4

Adjust the angle.
Grasp the Support Pillar with
both hands and rotate it by 45°
following the direction of the
arrow.
5

5
 2       
Height
Adjustable


G
D
F
J-1
J-2
H
3
!!
Please fix the nut G with wrench J-2 while
J-1 screwing bolt F.

6
      
 
First of all, make sure the diameter of the Bolt(M-A to M-E) your TV requires. Once you have
determined the correct diameter,please see the diagram as below. You will thread the Bolt
into the TV using the correct Washer(M-H), and using the spacer(M-G,W-F) if necessary.
Please make sure the Monitor Brackets are vertically centered and level with each other.
M-A/M-B/M-C
M-D/M-E
M-H
M-F/M-G
4

7
        
 



8

I

9
