Bosch SMI50C02GB User manual

Operating Instructions - Dishwasher Bosch SMI50C02GB
Control panel
1. ON/OFF switch
2. Door Opener
3. Programme selector
4. START button
5. Digital display
6. Timer programming *
7. Additional options **
8. Rinse aid refill indicator
9. Salt refill indicator
10. Display “Check water supply”
*Depending on model
**Number depending on model
Overview of Programmes
Select a suitable programme according to the type of utensils and degree of soiling.
The maximum possible number of programmes is illustrated in this overview:

Additional Options
Additional options can be set with the buttons
Express Wash/Speed Perfect/(VarioSpeed)*
This function can reduce the running time by approx. 20-50% depending on the selected rinse
programme. The change in the running time is indicated on the digital display. To obtain optimum
cleaning results at a reduced running time, water and energy consumption are increased.
Half Load *
If you have only a few items to wash you can switch to “half load”. This will save water, energy and time. It
is recommended to put a little less detergent in the detergent dispense than for a full load.
Hygiene *
The temperature is increased during the cleaning process. This increases the hygiene status. This
additional option is ideal for cleaning e.g. chopping boards and baby bottles.
Intensive zone *
Perfect for a mixed load. You can wash very soiled pots and pans in the lower basket together with
normally soiled utensils in the upper basket. The spray pressure in the lower basket is intensified, the
rinsing temperature is increased slightly.
Extra drying *
An increased temperature during the final rinse and an extended drying phase ensure that even plastic
parts dry better. There is a slight increase in the energy consumption.

Switching on the appliance
1. Switch the ON/OFF switch
2. Rotate programme selector to the required programme. The expected programme duration flashes on
the digital display.
3. Press START button. The programme starts running.
Remaining running time display
When the programme is selected, the remaining running time of the programme is indicated on the digital
display.
The running time is determined during the programme by the water temperature, the number of utensils
as well as the degree of soiling and may vary depending on the selected programme.
Timer programming *
You can delay the start of the programme in 1-hour steps up to 24 hours.
•Close the door
•Switch the ON/OFF switch
•Press button 6 until the digital display jumps to
•Press button 6 until the displayed time corresponds with your requirements.
•Press START button, timer programming is activated.
•To delete the preselected starting time, press the button 6 until is indicated on the digital display.
•You can change your programme selection at any time until the programme starts.
End of programme
The programme has ended when the value is indicated on the numerical display.
Switching off automatically after the end of the programme *
*depending on model
To save energy, the dishwasher is switched off 1 minute after the programme ends.
At the end of the programme please open the door fully and not partially when emptying the dishwasher.
Remove the utensils when they have cooled down.
Interrupting the programme
•Switch off ON/OFF switch, the LEDs go out. The programme is saved.

•If the door was opened on an appliance which has a warm water connection or is heated, first leave
the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the
appliance door to spring open or water to run out of the appliance.
•To continue the programme, switch on the ON/OFF switch again.