Bounce Hair Styler Operating and maintenance manual

&QUICK REFERENCE GUIDE
By Keith Harris
INSTRUCTIONAL
MANUAL
BounceInstructManualF51811.qxd 5/18/11 11:59 AM Page 1

TABLE OF CONTENTS
Important Safety Instructions............................................................................................................................02
Operating Instructions........................................................................................................................................03
Quick Reference Guide.......................................................................................................................................04
Tips / User Maintenance Instructions ..............................................................................................................09
a. Cleaning and Care ..................................................................................................................................09
b. Storage ......................................................................................................................................................09
c. Disposal ....................................................................................................................................................09
BounceInstructManualF51811.qxd 5/18/11 11:59 AM Page 3

When using electrical appliances, especially when children are present, basic safety precautions should always be followed,
including the following:
READ ALL INSTRUCTIONS BEFORE USING
KEEP AWAY FROM WATER
DANGER -As with most electrical appliances, electrical parts are electrically live even when the switch is off.
To reduce the risk of death by electric shock:
1. Always “unplug it” immediately after using.
2. Do not use while bathing
3. Do not place or store appliance where it can fall or be pulled into a tub or sink.
4. Do not place in or drop into water or other liquid.
5. If the BOUNCE™ falls into water, “unplug it” immediately. Do not reach into water.
WARNING -To reduce the risk of burns, electrocution, fire or injury to persons:
1. The BOUNCE™ should never be left unattended when plugged in.
2. Close supervision is necessary when this appliance is used by, on or near children or individuals with certain disabilities.
3. Use this appliance only for its intended use as described in this manual.
4. Never use if it has a damaged cord or plug, if it is not working properly, or if it has been dropped, damaged or dropped
into water.Return the appliance to a service center for examination or repair.
5. Keep the cord away from heater surfaces. Do not wrap the cord around the BOUNCE™.
6. Never use while drowsey.
7. Do not place or store appliance where it can fall or be pulled into a tub or sink.
8. Do not place in or drop into water or other liquid.
9. If falls into water, “unplug it” immediately. Do not reach into the water.
10. Connect this appliance to a properly grounded outlet only.
11. The BOUNCE™ is hot when in use. Do not let eyes and bare skin touch heated surfaces.
12. No not use an extension cord with the BOUNCE™.
13. Do not place the heated BOUNCE™ directly on any surface while it is hot or plugged in. Use the stand provided.
14. Do not use outdoors.
SAVE THESE INSTRUCTIONS FOR HOUSEHOLD USE ONLY
IMPORTANT SAFETY INSTRUCTIONS
2
BounceInstructManualF51811.qxd 5/18/11 11:59 AM Page 4

Before plugging BOUNCE™ into power source first check the outlet
voltage corresponds to the voltage marked on the appliance.
USAGE:
1. Unpack the BOUNCE™ and check
for any damages.
2. Keep the BOUNCE™clean.
3. Allow the BOUNCE™ to cool down
before storing away after use.
4. In case of damage or malfunction do not
attempt repair
5. Do not use BOUNCE™ with wet or damp hands.
6. Only use BOUNCE™ on real human hair.Do not
use on artificial or animal hair.
This BOUNCE™ has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact qualified electrician. Do not attempt to defeat
this safety feature.
Preparing the Unit
Step 1: Plug the BOUNCE™ into power outlet.
Step 2: Turn the “Temperature Switch” to the temperature setting that is most suited to your hair. LOW setting is most suitable for thin hair,
while HIGH setting is suitable for thick hair. For First-time users, it is advisable to start at a lower temperature setting and gradually
increase the heat setting to find the most suitable temperature.
Step 3: Slide the “ON/OFF switch” to “HIGH” or “LOW”, indicator light will light up, indicating the power supply is working properly.
Please read these operating instructions carefully before you begin using the BOUNCE™.Use appliance for intended purpose. In no event
will the product supplier or manufacturer be liable for any special, incidental or consequential damages caused by incorrect operation. Such
damages include, without limitation, loss of savings, income or revenue; loss of profit, loss of use; the claims of third parties and cost of any
substitute equipment or services.
Heat
Resistant
Tips
Heat Resistant Fabric
Indicator Light
ON/OFF Switch
High Low
360˚ Swivel Cord
OPERATING INSTRUCTIONS
3
www.bouncetutorial.com
BounceInstructManualF51811.qxd 5/18/11 11:59 AM Page 5

QUICK REFERENCE GUIDE
4
BOUNCE™ is a very visual learning product. For best results refer to the “How To DVD” for better understanding or visit
www.bouncetutorial.com
Step 1:
For best results wash (optional) & dry hair thoroughly. Hair must be dry and clean for the BOUNCE™ to work at its best; there
is no need to use gels, conditioners, setting lotions or sprays to hold the volume.
Step 2:
Style your hair as you normally would. For example, curl or flat iron your hair to your liking. Do not add gels, or sprays
at the root’sof your hair.
Step 3:
Plug in the BOUNCE™ and set the temperature switch to the setting that best fits your hair type. The orange light will indicate your
BOUNCE™ is turned on; the bounce will take a few minutes to reach the optimal operating temperature. Use the “low” setting for thin,
fine hair types or color treated hair. Use the “hi” setting for thicker, coarse hair types, if you are unsure start in the low setting.
www.bouncetutorial.com
BounceInstructManualF51811.qxd 5/18/11 11:59 AM Page 6

B) Start at your eyes and separate the hair back to the crown of
the head; clip up one side to start creating the volume you want.
Be aware of the hair you leave out, you do not want to use the
BOUNCE™ on hair that will show when you are finished. This
will be used to cover the waves created by the BOUNCE™.
QUICK REFERENCE GUIDE
5
Step 4:
A) Create a V shaped section in your hair by creating a part line
that separates your hair.
A
B
www.bouncetutorial.com
BounceInstructManualF51811.qxd 5/18/11 11:59 AM Page 7

6
QUICK REFERENCE GUIDE
Step 5:
A) Start working with two inch sections about 1/2 of an inch
thick at a time below the part line you just created. Remember
to keep the BOUNCE™ 1/4 inch from your scalp to avoid
contact with the hot tool.
A
B) Lift the section of hair upward at a right angle from the head
or higher and hold tightly. Place the hair in the BOUNCE™,
close, and hold for a couple of seconds, move the BOUNCE™
1/4 of an inch out and hold for a couple of seconds. You just
made two wave formations.
B
2 inches
1/4”
away
from
Head
www.bouncetutorial.com
BounceInstructManualF51811.qxd 5/18/11 11:59 AM Page 8

7
QUICK REFERENCE GUIDE
C) Release and angle BOUNCE™ down
to hold hair a third time, curve the
BOUNCE™ downward, creating an upside
down “U” shape with your hair; hold for
acouple seconds (please refer to the DVD
for a complete visual). Release the hair
and you have completed your first section.
You will see the volume you created
instantly. It is important to work in
small sections for optimal results.
C
D) Leave a 2 inch area to hide the wave
formation created by the BOUNCE™.
DO NOT BOUNCE™ this area.
D
Step 5: Step 6:
Continue working in small sections across
the hair, as described in Step 5 along the
part line until you have reached the crown.
2 inches
www.bouncetutorial.com
BounceInstructManualF51811.qxd 5/18/11 11:59 AM Page 9

8
QUICK REFERENCE GUIDE
Step 7:
A) Next, let down a small layer of hair
from the clip, maintaining the V section.
This section will cover the previous
Bounced section of hair. Continue with
the process described in Step 5 and
Step 6 for remainder of the hair.
A
B) Side is complete. Remember to leave
enough hair in the clip to cover the waves
from the BOUNCE™.
B
Step 8:
Move to the other side of the head and
repeat Step 4 – Step 7.
New section of hair to Bounce
Covering the previosuly
Bounced hair
www.bouncetutorial.com
BounceInstructManualF51811.qxd 5/18/11 11:59 AM Page 10

9
TIPS / USER MAINTENANCE INSTRUCTIONS
BOUNCE™ has no user serviceable parts, and is virtually maintenance free. Do not
attempt to repair if any malfunction occurs.
No lubrication is needed. Keep heated surfaces clean and free of dust, dirt, and hair
spray. If the cord becomes twisted, untwist prior to use.
Cleaning Instructions:
1. Unplug the BOUNCE™ from the power source and let it cool off.
2. Clean all parts with slightly damp cloth.
3. Wipe all parts dry with a dry cloth.
Storage
When not in use, “unplug it”
Unplug the BOUNCE™ from the power outlet and allow it to cool before storing away.
Avoid contact between the iron and the power cord.
Store out of reach of children in a safe, dry location. Never wrap the cord around the
BOUNCE™ since this will cause the cord to wear prematurely and break. Handle cord
carefully for longer life and avoid jerking, bending sharply,twisting, or straining cord,
especially at plug connection.
Disposal
Appliance that has come to the end of its service life must undergo proper disposal in
accordance with the law. Plastics and electronic parts must be submitted for recycling.
Enquire with our municipal waste disposal authority for disposal directions.
TIPS:
• Watch the BOUNCE DVD and go to
www.bouncetutorial.com
• To create more volume and BOUNCE™
add more layers and BOUNCE™
more sections.
• For more lift at the root, lift each section
of hair as high as you can when using the
BOUNCE™ this will create more volume.
• Start with the low setting and if you want
more volume try the “HIGH” setting.
• Do not use the BOUNCE™ in an area
you do not want to see the markings.
• When you have achieved your desired
volume, run your hands through your
hair to loosen up and reshape your hair,
use your hands as your styling brush
massaging the area you have Bounced
at the scalp….miraculously you will
see the volume grow even more with
this technique.
www.bouncetutorial.com
BounceInstructManualF51811.qxd 5/18/11 11:59 AM Page 11

Distributed by:
Before
After
Before
After
Before
After
www.bouncetutorial.com
Thane International, Inc.
La Quinta, CA 92253, U.S.A.
www.thane.com
Thane Direct Canada Inc.
Mississauga, ON L4W 5M6, Canada
www.thane.ca
Thane Direct UK Ltd.
Admail ADM3996, London W1T 1ZU, U.K.
www.thanedirect.co.uk
BounceInstructManualF51811.qxd 5/18/11 11:59 AM Page 12