BRAVUR BW003 User manual
Thank
You!
Thank you for purchasing a Bravur
watch!
In this manual you can learn more about
your watch and how to take care of it.
We hope you will be happy with your
watch for many years. In case of
anything, don’t hesitate to contact us.
Best regards,
Johan & Magnus,
Founders of Bravur
02. Set time & date
03. Adjust strap length
04. Care & maintenance
05. Watch specifications
06. Measurements
07. Warranty
08. Contact information
01.
Content
Manual winding
Set time
Set date/ GMT*
1
2
3
02.
Set time
& date
CROWN
POSITIONS
1
2
3
In case your watch has stopped after not
being used for a period of time, its
recommended to manually wind it to
start. This is done with the crown in
position 1, which is its normal position
during use. The crown should be turned
clockwise, approximately 15 turns.
The crown must be in position 1 to be
protected from water.
Turn the crown counterclockwise for
adjustment of date. Do not set the date
between 9 PM and 1 AM as this will
make the date shift at noon instead of
midnight.
*Turn clockwise for adjustment of GMT
hand.
* Applies only to GMT models
To set the time, pull out the crown two
steps from position 1. Please note that the
second hand will stop in this position.
CROWN
POSITIONS
1
1
2
2
3
Open the clasp
Adjust length
3
4
4
Close the clasp
Close the buckle
03.
Adjust strap
length
Please follow these guide lines to get the
best out of your watch.
Movement
If the watch is worn daily for about 12 h, the
movement is automatically winded by its
rotor and no manual winding is needed.
However if the watch has stopped since not
used for a period of time manual winding is
recommended to start it. This is done with
the crown in position 1. The crown should be
turned clockwise, approximately 15-20
turns.
To fully wind the movement 65 turns are
required. Daily manual winding is not
recommended since the movement is not
designed for this.
The accuracy stated in the specifications
section may change over time. As a
mechanical watch, quartz watch accuracy
cannot be expected.
Magnetic fields
Avoid placing your watch on electronic units
which can generate strong magnetic fields,
e.g. loudspeakers, since this can affect the
watch performance.
Shocks
It is recommended to avoid exposing your
watch to mechanical and thermal shocks, as
it may damage your watch and delicate
movement parts.
Service
Your watch consists of hundreds of small
parts and needs service regulary to maintain
its performance and accuracy. Full service is
advisable every 4-5 years. It is
recommended to be performed by an
approved watch maker or sent to Bravur
service center. Contact us for more
information.
Cleaning
To clean your watch, use a tooth brush and
some water and mild detergent. Do not rinse
the watch under water and avoid the leather
strap to come in contact with water.
Water resistance
Your watch is tested to resist 5 ATM of static
pressure. Please note that this is not equal to
resistance in water. Your watch will withstand
everyday use like light rain or high humidity,
but please leave your watch on the poolside
when going for a swim, and leave it outside
the shower or sauna.
Gaskets and seals should be inspected and
replaced by a watch maker to maintain full
water resistance.
Leather straps
Avoid leather and nubuck straps to come in
contact with water, as it will shorten its
life-span.
04.
Care &
maintenance
Please follow these guide lines to get the
best out of your watch.
Movement
If the watch is worn daily for about 12 h, the
movement is automatically winded by its
rotor and no manual winding is needed.
However if the watch has stopped since not
used for a period of time manual winding is
recommended to start it. This is done with
the crown in position 1. The crown should be
turned clockwise, approximately 15-20
turns.
To fully wind the movement 65 turns are
required. Daily manual winding is not
recommended since the movement is not
designed for this.
The accuracy stated in the specifications
section may change over time. As a
mechanical watch, quartz watch accuracy
cannot be expected.
Magnetic fields
Avoid placing your watch on electronic units
which can generate strong magnetic fields,
e.g. loudspeakers, since this can affect the
watch performance.
Shocks
It is recommended to avoid exposing your
watch to mechanical and thermal shocks, as
it may damage your watch and delicate
movement parts.
Service
Your watch consists of hundreds of small
parts and needs service regulary to maintain
its performance and accuracy. Full service is
advisable every 4-5 years. It is
recommended to be performed by an
approved watch maker or sent to Bravur
service center. Contact us for more
information.
Cleaning
To clean your watch, use a tooth brush and
some water and mild detergent. Do not rinse
the watch under water and avoid the leather
strap to come in contact with water.
Water resistance
Your watch is tested to resist 5 ATM of static
pressure. Please note that this is not equal to
resistance in water. Your watch will withstand
everyday use like light rain or high humidity,
but please leave your watch on the poolside
when going for a swim, and leave it outside
the shower or sauna.
Gaskets and seals should be inspected and
replaced by a watch maker to maintain full
water resistance.
Leather straps
Avoid leather and nubuck straps to come in
contact with water, as it will shorten its
life-span.
Movement
Swiss Made Sellita SW300-1, 25 jewels
GMT: Swiss made Sellita SW330-1,
25 jewels/
Swiss Made ETA 2893-2, 21 jewels
Power reserve
42 h
Frequency
28 800 (4 Hz)
8 beats per second
Accuracy
Daily rate +/- 5 s/d
Isochronism (after 24h) +/- 15 s/d
Manually winding
Min. 65 turns to full power reserve
(manual winding not needed during regular,
daily use)
Case
Solitär, Swedish stainless steel, 39 mm
05.
Watch
specifications
Case back
Stainless steel (SB version)
Sapphire (DB version)
Lug width
20 mm
Crystal
Domed sapphire, inside anti-reflective
coating.
Water resistance
5 ATM
HANDBUILT IN
SWEDEN
Movement
Swiss Made Sellita SW300-1, 25 jewels
GMT: Swiss made Sellita SW330-1,
25 jewels/
Swiss Made ETA 2893-2, 21 jewels
Power reserve
42 h
Frequency
28 800 (4 Hz)
8 beats per second
Accuracy
Daily rate +/- 5 s/d
Isochronism (after 24h) +/- 15 s/d
Manually winding
Min. 65 turns to full power reserve
(manual winding not needed during regular,
daily use)
Case
Solitär, Swedish stainless steel, 39 mm
Case back
Stainless steel (SB version)
Sapphire (DB version)
Lug width
20 mm
Crystal
Domed sapphire, inside anti-reflective
coating.
Water resistance
5 ATM
HANDBUILT IN
SWEDEN
06.
Measurements
Steel case back: 10,1 mm
Sapphire case back: 10,3 mm
GMT: 10,5 mm
39 mm
20 mm
44,5 mm
S
W
E
D
I
S
H
S
O
U
L
S
W
I
S
S
H
E
A
R
T
S
O
L
I
T
Ä
R
0
0
0
0
S
W
E
D
I
S
H
S
O
U
L
S
W
I
S
S
H
E
A
R
T
S
O
L
I
T
Ä
R
0
0
0
0
Steel case back
Sapphire case back
07.
Warranty
Your Bravur watch has a full two year
warranty from the original date of purchase.
The warranty covers any need of repair due
to defects in the materials or workmanship
under normal use.
Bravur obligations hereunder are limited to
repair or replacement at its option.
The warranty excludes the strap/bracelet
and excessive wear or damage to the case,
plating, crystal or strap.
The warranty does not cover periodic
service and maintenance.
Improperly or incorrectly performed service
and maintenance, repairs or servicing voids
the warranty. Any service and maintenance,
repairs or servicing which requires opening
of the case, must be performed by a
properly qualified watchmaker.
www.bravurwatches.com
Table of contents
Other BRAVUR Watch manuals
