Brickhouse Security JumpStart Solo User manual

JumpStart Solo
User’s Guide

Package Content
•1x JumpStart Solo, Car Jump Starter
•1x Smart Clamps
•1x USB Micro Cable
•1x User Manual

Smart Clamps
JumpStart Solo

Operation
Please read this manual carefully before operating
the JumpStart Solo.
Press the power button lightly to check the remaining battery capacity.
Whilethejumpstarterisbeingcharged,theindicatorlightswillashone
by one until it reaches maximum charge. All 4 indicator lights will stay on
when the jump starter is fully charged.
Indicator lights 4 OFF 1 Solid ON 2 Solid On 3 Solid On 4 Solid ON
Battery 0% 25% 50% 75% 100%

Indicator lights 4 OFF 1 Solid ON 2 Solid On 3 Solid On 4 Solid ON
Battery 0% 25% 50% 75% 100%

How to Jump Start a Vehicle Battery:
1. Make sure the battery capacity of the jump starter is above 25% (At
least one indicator light stays ON).
2. Connect the jump start cable to the proper socket of the jump starter.
3. Connect the jump start cable to the drained battery of the vehicle.
Connect red clamp to the positive “+” terminal and black clamp to the
negative “-” terminal.
4. Now attempt to crank start the engine. If engine does not start, wait at
least 10 seconds before attempting to start the engine again.
5. Disconnect the jump starter cable from the jump starter within 10
seconds after the engine has been successfully started.

Recommended Vehicle Engine Displacements
for Jump Starting:
1. Insert the plug of the smart clamp completely into the jump starter, and
thegreenlightwillash.
2. Correctly clip the red and black clamps to the electrodes of the car
battery (Red to positive and black to negative).
3. Start the vehicle.
4. When the vehicle is started, remove the smart clamp from the vehicle
battery.
WARNING! Do not touch the red and black clamps together or
connect both to the same piece of the metal to prevent physical
injury and damage to the vehicle.
Do not use the jump start cable for any other purpose other than
jump starting the vehicle.
KEEP AWAY FROM CHILDREN AT ALL TIMES!

How to Turn On the LED Light:
Press and hold the power button for 3 seconds to turn on the LED light.
Once the LED light is turned on, pressing the power button will cycle
through additional modes.
(Solidlight-->Strobelight-->SOSashing-->OFF)
Charging Mobile Electronic Device:
1. The jump starter has one 5V USB output port and make sure the
electronic device is 5V powered.
2. Connect the USB cable to the USB output port on the jump starter.
3. Attach the compatible charging adapter plug to the supplied USB cable
and plug into the electronic device.

How to Charge the Jump Starter:
WARNING! Any other chargers may cause possible damage
and/or reduce the service life of the jump starter.
Specications
Input: 5V/1.5A Output: 5V/2.1A
Current: 250-500A Charging time: around 6h
Size: 140*85*27mm
Operating Temperature:-20℃~+60℃
Keeping Temperature:0℃~+45℃
Connect the Included Micro USB Cable into a 5v adapter (not included),
then insert the cable into the micro USB port of the device.