Brother BE-1204 User manual

3/10/05
1
With the power to the machine OFF.
1. Remove the black thumbscrews.
3. Open the two fixed levers and move the fixing
pins to the outside to take them out from the
pantograph.
5. Install tubular arms. Flip mode switch on
machine to FLATS. Turn power on.
2. Hold up the cap frame sash and remove it from the
positioning pins by moving slightly forward.
4. Remove the cap driver from the bed and fix the cap
frame sash with the black thumbscrews, removed in
step 1, for storage.
For Technical Assistance Please Call Toll Free
1
-
877
-
4BROTHER
Email: [email protected]
Website: http://www.brother-usa.com/industembroidery/tech_down.aspx
B
BE E- -1 12 20 04 4, , 1 12 20 06 6
Positioning Pin
Open
Outside

3/10/05
2
There are 3 tubular mounting positions depending on what hoop size you are using. On each side of the
tubular arms are numbers 1-3. If for example you are using small tubular hoops you would use position
number 1 on both tubular arms. This is the numbered slot on the tubular arm that will go under the pair
of thumbscrews for each head on the pantograph. Only the left tubular arm moves to a different position.
The right one is fixed. To adjust the tubular arms on the connecting plate just remove the small
thumbscrew on the left hand side and remove that tubular arm. Insert the number 1 slot of the right
tubular arm underneath the pantograph thumbscrew on the right. Install the left tubular arm so that the
number 1 slot is underneath the pantograph thumbscrew on the left. This will align the left tubular arm
with the correct positioning pins on the connecting plate. Install small thumbscrew to secure left tubular
arm to the connecting plate. Tighten both thumbscrews on pantograph to secure the tubular attachment.
Photos of each position are as follows:
Position 1
Position 2 Position 3
B
BE E- -1 12 20 04 4C C T Tu ub bu ul la ar r P Po os si it ti io on ns s
Small Thumbscrew
Pantograph Thumbscrews