BTEK BT075 User manual

INSTRUCTIONMANUAL
BT075
FCCID:OYCBT075

WARNINGS
Thisapplianceisintendedfordomestichouseholduseonlyandshouldnotbeusedforanyotherpurpose
orinanyotherapplication,suchasfornondomesticuseorinacommercialenvironment.


OVERVIEW

PlayorPause
Hands‐freecallcontrolbutton
 Turnon/Turnoff
BLUETOOTHOPERATION
1. Turnonthespeaker.TheindicatorlightwillflashtodetectBluetoothenableddevicesnearyou.The
indicatorlightwillgooffifnoBluetoothdeviceisdetectedwithin5minutes.
2. PairthespeakerwiththedesiredBluetoothdevice.
3. Play/pauseasdesiredbypressing.  Turnon/Turnoff
4. WhenyouwanttoplaymusicormoviefromanotherBluetoothdevice,disconnectthespeakerand
restarttheBluetoothspeakerandre‐pair.

Tip:Pressandholdfor3secondstodisconnectquickly.

AUXPLAYBACKOPERATION
1. Turnonthespeaker.
MicroUSBChargingPort
Note:The USB Port not transfer data via PC
3.5mmAuxin
Play/Pause/Hands‐freeCall/TURN
ON/TURNOFF

2. Insertan3.5mmaudiocableintotheauxjackonthebackofthespeaker,connectingtoanyaudio
devicesuchasmobilephonesorcomputerswiththeotherendofthecable.
3. Play/pauseasdesiredbypressing.

CHARGINGTHESPEAKER
Thespeakerhasabuilt‐inLithiumbattery.Thebatteryisrechargeableandprovidesapprox3‐hour
continuousoperationwhenfullycharged.

Usethemicro‐USBcabletochargethespeaker.Theredindicatorlightwillilluminate.Theredindicator
lightwillgooffwhenthespeakerisfullycharged.

SPEAKERPHONEOPERATION
Press  toansweranincomingcall.
Press  tohangup.
Keeppessingtorejectanincomingcall.
Doublepresstoredialthelastphonenumber.

SPECIFICATION
ProductModel：BT075
BluetoothSpecifications：BluetoothV4.0
TransmissionDistance：≤10M(dependinguponoperationenvironmentanddevicestowhichitconnects)
USBRechargeVoltage:DC5V
Built‐inBattery:Lithiumbattery1050mAh
OutputPower:5W*2
FrequencyResponse:90Hz‐20KHz
Sensitivity:80db±2db
SignaltoNoiseRatio(SNR):≥80dB
ProductDimensions:65*65*120MM
Accessories
IB*1
MicroUSBchargingcable*1
3.5mmaudiocable*1

FCCStatement:
This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: Modifications to this product will void the user’s authority to operate this equipment.