CAREFULLY READ THIS OPERATING MANUAL TO USE
AND ENJOY THIS UNIT PROPERLY.
KEEP THIS MANUAL HANDY FOR FURTHER REFERENCE.
BATTERY AND POWER
1. Retro Pager is charged via the USB charging cable included. Plug it in to
charge. When charging, the LED indicator will be red. When your Retro Pager
is done charging, the LED indicator will turn blue.
2. When your unit needs a charge, the LED indicator will be red, it will also
play a “battery low” tone.
BLUETOOTH CONNECTION
1. Press and hold the power button for 3 seconds. Ablue light will flash,
indicating the unit is in Bluetooth Pairing Mode.
2. Open your smart device, and find “Bumpboxx Pager” on the devices list.
3. A blue light will flash when Bluetooth pairing is taking place or when
Pager is in standby or ready to pair.
4. Choose Connect.
5. Pairing time in Bluetooth mode is 3 minutes, if no device is connected it
will automatically exit pairing mode.
TWS Pairing (link two pagers)
While two pagers are powered on (make sure your phone is not connected)
on one pager double click the power button with two taps. “Mode button”
to prompt “TWS MODE”. At this time youre in TWS pairing mode, Perform
the same operation on the second pager , the two speakers are automatically
paired and you will hear a “beep beep” prompt sound.
FUNCTION DESCRIPTION RESOLViNG COMMON iSSUES
1 2
If yours device cannot be found in Bluetooth Mode:
1. Check if the Retro Pager is in Bluetooth Pairing mode
(the blue LED indicator will flash quickly)
2. Check if Pager is already connected to another device.
3. Make sure the Pager has a full charge and try again.
4. Make sure your device is within range to speaker.
If you have on going issues with your Retro Pager please contact
Bumpboxx Customer Support at Customerservice@Bumpboxx.com
