C-lock GreenFeed User manual

Upgrading GreenFeed
for Mobile App Use
You will need:
1) #2 Philips Screwdriver
2) #1 Philips Screwdriver
3) 5/32nd Allen Screwdriver
4) A Plastic Bag (large enough to fit around the food drop nozzle)
5) Sticky Tape (scotch, masking, electrical, or duct)
6) Scissors or side-cutters (to cut zip ties)
7) All the Contents of the Package
Highly Recommended
1) Flashlight

Shut Off GreenFeed
•Put the unit to sleep – From the main status
screen, press SLEEP, then press ENTER to put
the unit to sleep.
•Wait for data to upload – then press the
“PWROFF” button
•Wait 10 seconds, then unplug main power
from the unit.

Use the 5/32nd Allen Screwdriver to
Remove the Dish Bolts

Unscrew and Unclip the Tracer Nozzle

Remove the Food Dish
You may need a flat-blade screwdriver
to pry the dish above the plastic lip

Remove the Tray and Cover the Food Nozzle
Plastic Bag

Unscrew the 6 Plastic Screws and Remove the Box Lid

Unplug the USB and Ethernet Cables

Remove the BeagleBone
The board is friction-fit onto the board.
The easiest way to remove it is to place
your fingers/thumb on the top and bottom
of the board and wiggle the board back
and forth while gently pulling it up.

Orient the New BeagleBone
Once installed, the new board should have
the antennas facing the back of the box,
and the USB connector facing toward the
front of the box, as shown in this photo.
Proceed to the next page for installation of
the board.

Lay the New BeagleBone in Place
Make sure the top-left pin lines up
Make sure the bottom right pin lines up
Once it’s set in place and lined up
correctly, gently press down to seat it.
The board should be firmly held in place.

Ensure the Board is Pressed Fully In
This board is *not* pressed in all the way.
This board *is* pressed in all the way.
Only a tiny bit of the pins should be
showing.

Remove the USB WiFi Dongle
The USB WiFi dongle is a small USB
device plugged into the USB hub.
Remove it completely from the system.
It should read “Panda” or “80211”

Route the New USB cable
Connection
Point
A USB extension was included in
the shipment.
This is needed since the USB port
is on the bottom of the new circuit
board (instead of the top)
Use the extension USB cable to
connect the old USB cable to the
port of the new circuit board.
See photo for routing.
Orange = USB Cable already
installed in system.
Red = New Extension USB Cable

Install Optional Ethernet Port
If your system included the
Ethernet-to-USB adapter:
1) Install the USB adaptor in any
of the open ports on the USB hub.
2) Change the routing of the
ethernet cable from point A
(orange) to point B (red)
3) Plug the ethernet cable into the
Ethernet-to-USB adapter.
1) USB Hub
2) Point “A”
2) Point “B”
3) Connect the cable

Turn On GreenFeed
•Before closing up the box, it may be best to
power on GreenFeed and ensure everything is
working correctly.
•Power on GreenFeed and wait ~5 minutes,
then call or email C-Lock
con[email protected]om
[phone]