Caliber CAL-F4040 User manual

FIXED TV
WALL MOUNT BRACKET
Nov 2013
DISTRIBUTED BY RVM AUSTRALIA t: [phone] e: [email protected]
STEP 1
Professional Installer Highly Recommended
The manufacturer will not warrant any faulty installations,
and damage to existing structures or any other
fixtures / fittings as a result of incorrect installation.
CAL-F4040
HIGH CALIBER WALL MOUNTING SYSTEMS
STEP 4
STEP 3
Mount bracket to wall. STEP 2
2
2
2
3
1
1
1
STEP 3
4
5
Locate screw fixtures in the back of your TV and attach
railings (2) using the screws provided.
The screw size required will vary on each TV so we have
provided you with a range to choose from (M5, M6, M8).
Optional: Insert spacers if back of TV is not a flat.
Once the railings (2) are firmly
attached to the TV hook the railings
onto the wall bracket (1).
Slide the locking bar (3) through
bracket (1) guide holes and holes in
both railings (2) to secure them into
place. Use locking pin (4) provided to
secure locking bar.
Select a position for the wall bracket (1). If screwing into a
plasterboard wall, use a stud finder to locate a beam behind the
plasterboard to secure to. If fixing to a concrete/brick wall, we
recommend the use of plastic wall anchors (6). Using the wall
bracket as a stencil, hold the wall bracket in position and use a
pencil through the screw holes to mark the locations on the wall for
drilling. (See Additional Tools required section for drill bit sizes) Affix
to wall using wall screws (5).
IMPORTANT: PRE-DRILL HOLES
Make sure bracket is secured to joists,
or anchors are used for concrete.
Mount railing to TV.
Fasten mount to bracket.
Position mount over bracket.
C
M
Y
CM
MY
CY
CMY
K
CALF4040.pdf 1 13/12/2013 2:24:57 PM

x4 x4
CAL-F4040
FIXED TV
WALL MOUNT BRACKET
PARTS DRAWN TO SCALE 1:1
NOTE: Use spring washers when securing bolts. This will reduce the risk of bolts coming loose.
PARTS LIST
ADDITIONAL TOOLS REQUIRED
HIGH CALIBER WALL MOUNTING SYSTEMS
A drill will be required to drill
pilot holes for the arm bracket.
Masonry Wall - 9mm bit
Studded Wall - 5mm bit
A socket wrench will be
required wherever
you see this icon.
Hex Socket
A phillips head
screwdriver will be
required wherever you
see this icon.
Nov 2013
DISTRIBUTED BY RVM AUSTRALIA t: [phone] e: [email protected]
M8
Spring
Washer
x4
M5
Spring
Washer
x4
Spring
Washer
x4
M6
4. 5. 6. 7.
No. Part Qty
1 Wall Bracket 1
2 Railings 2
3 Locking Bar 1
4 Locking Pin 1
5 Wall Screws 4
6 Wall Anchor 4
7 Washer 4
No. Part Qty
C
M
Y
CM
MY
CY
CMY
K
CALF4040.pdf 2 13/12/2013 2:24:57 PM