control standby mode. It will enter into video mode, record for 3 minute and save again if the outside
sound reaches 65 decibels again. It goes full circle.
3) Standby mode: Under sound-control video mode, short press the function key and the light is on. The
device will quit from sound-control mode and save the files. It will enter into the standby mode (under
the standby mode, the machine will power off if no action in 2 minutes).
4) Take pictures: Under the standby mode, press the function to take pictures. The indicator light puts out
and then on and save it as a *. JPG file.
5) Video: Under the standby mode, long press the function key for 2 seconds to start the video. The light
will flash continuously. When pressing the function key again to stop the video, the light is on and save it
as a *.AVI file.
6) Power off: Long pressing the power key for 4 seconds, the light flashes twice and then off. The device is
shut down. The current recorded file will be saved before shutting down.
7) Low battery: lf the battery is low when using, the light will flash twice and the machine will be off. The
current file will be saved before off.
8) Charge: Connecting the device to the computer or power adapter can charge. The light will been on
while charging and will be off after full.
9) Storage card is full: The light is long on and the device enters into the standby mode. No response to the
order of video and pictures. It will be off automaticity after 2 minutes.
4. File storage
After finishing the record on taking pictures, using USB to connect the device with the computer, can copy or cut
the video to the computer and play.
Attention: If the device is shut down, it will be used as USB disk when connecting with the computer.
5. PC camera function
This device can be used as PC camera. Install the software driver before using. Connect the device to the
computer. A standard video device will appear and it could be used as the camera.
Attention: After this device turns on all right, connecting it with the computer could be used as camera.
6. Set time
Create a new file named TIME.TXT and the format as follows:
2007.04.22 11:20:30
It corresponds to be (Annual.Month.Date Hour.Minute.Second). Copy this file to the root directory and after
removing the removable storage device, turning on the device and recording and then turning off normally, the
new time could be set successfully.
10101 Yonge Street, Unit 3
Richmond Hill, ON. L4C 1T7
Tel. (905) 884-8338
